74LVTH273MTCX
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 20 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Series | 74LVTH |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 2.7V~3.6V |
| Base Part Number | 74LVTH273 |
| Function | Master Reset |
| Output Type | Non-Inverted |
| Operating Supply Voltage | 3.3V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Circuits | 8 |
| Clock Frequency | 150MHz |
| Propagation Delay | 5.5 ns |
| Turn On Delay Time | 4.9 ns |
| Logic Function | D-Type, Flip-Flop |
| Current - Quiescent (Iq) | 190μA |
| Current - Output High, Low | 32mA 64mA |
| Max Propagation Delay @ V, Max CL | 4.9ns @ 3.3V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 3pF |
| Number of Input Lines | 4 |
| Number of Output Lines | 7 |
| Clock Edge Trigger Type | Positive Edge |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
74LVTH273MTCX Overview
It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. The Tape & Reel (TR)package contains it. T flip flop uses Non-Invertedas the output. JK flip flop uses Positive Edgeas the trigger. Surface Mountmounts this electrical part. A 2.7V~3.6Vsupply voltage is required for it to operate. In this case, the operating temperature is -40°C~85°C TA. This D latch has the type D-Type. JK flip flop is a part of the 74LVTHseries of FPGAs. This D flip flop should not have a frequency greater than 150MHz. There are 1 elements in it. T flip flop consumes 190μA quiescent energy. This D latch belongs to the family of 74LVTH273. The input capacitance of this T flip flop is 3pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. A part of the electronic system is mounted in the way of Surface Mount. A total of 20pins are provided on this board. This device has the clock edge trigger type of Positive Edge. The superior flexibility of this product is achieved by using 8 circuits. High efficiency requires the supply voltage to be maintained at 3.3V. The JK flip flop is with 7 output lines to operate. The number of input lines is 4.
74LVTH273MTCX Features
Tape & Reel (TR) package
74LVTH series
20 pins
74LVTH273MTCX Applications
There are a lot of ON Semiconductor 74LVTH273MTCX Flip Flops applications.
- Bus hold
- Single Up Count-Control Line
- Shift Registers
- Latch
- ESD protection
- Divide a clock signal by 2 or 4
- Set-reset capability
- Balanced 24 mA output drivers
- QML qualified product
- Dynamic threshold performance
