MAX17015AETP+
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 20-WFQFN Exposed Pad |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 20 |
| Terminal Finish | NOT SPECIFIED |
| Technology | BICMOS |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Terminal Pitch | 0.5mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 20 |
| JESD-30 Code | S-XQCC-N20 |
| Output Voltage | 5.35V |
| Input Voltage-Nom | 19V |
| Analog IC - Other Type | BATTERY CHARGE CONTROLLER |
| Input Voltage (Min) | 8V |
| Control Mode | CURRENT-MODE |
| Input Voltage (Max) | 26V |
| Control Technique | PULSE WIDTH MODULATION |
| Switcher Configuration | PUSH-PULL |
| Switching Frequency-Max | 1200kHz |
| Fault Protection | Over Current, Short Circuit |
| Battery Chemistry | Multi-Chemistry |
| Voltage - Supply (Max) | 26V |
| Current - Charging | Constant - Programmable |
| Charge Current - Max | 5A |
| Battery Pack Voltage | 2.1V |
| Height Seated (Max) | 0.8mm |
| Length | 4mm |
| Width | 4mm |
| RoHS Status | ROHS3 Compliant |
MAX17015AETP+ Overview
The Tube package contains it.It can be found in package 20-WFQFN Exposed Pad.Mounting type Surface Mount is chosen for the device.A temperature setting of -40°C~85°C TA would be the best thing to do.There is an analog IC of BATTERY CHARGE CONTROLLER used in this device.Providing Constant - Programmable current to the device is the only way to charge it.As far as the terminations are concerned, there are 20.This battery pack has a voltage of 2.1V.20 pins are on it in total.A maximum charging current of 5A is achieved by the part.In this case, the device's maximum supply voltage is 26V.Having the output voltage set to 5.35V may result in high efficiency.Input voltage is 19V.It is necessary to have a 8V volt input voltage.Ideally, the switching frequency of the part should be 1200kHz.With this device, the maximum input voltage is 26V.
MAX17015AETP+ Features
Battery pack voltage of 2.1V
20-WFQFN Exposed Pad package
MAX17015AETP+ Applications
There are a lot of Rochester Electronics, LLC MAX17015AETP+ Battery Chargers ICs applications.
- Home appliances
- Electricity bank
- Electrical Utility industry
- Remote powered communication and telemetry systems
- Automotive/electrical vehicle
- Model aircraft
- Painting boat
- Digital camera
- Shop charger
- Electric tour bus
