MC100EP451FA
| Parameters | |
|---|---|
| Supply Voltage-Min (Vsup) | 3V |
| Clock Frequency | 3GHz |
| Current - Quiescent (Iq) | 135mA |
| Output Polarity | COMPLEMENTARY |
| Number of Bits per Element | 6 |
| Trigger Type | Positive Edge |
| Propagation Delay (tpd) | 0.55 ns |
| Length | 7mm |
| Width | 7mm |
| RoHS Status | Non-RoHS Compliant |
| Mounting Type | Surface Mount |
| Package / Case | 32-LQFP |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tray |
| Series | 100EP |
| JESD-609 Code | e0 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 32 |
| Type | D-Type |
| Terminal Finish | TIN LEAD |
| Additional Feature | NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V |
| Technology | ECL |
| Voltage - Supply | 3V~5.5V |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.8mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| JESD-30 Code | S-PQFP-G32 |
| Function | Master Reset |
| Qualification Status | COMMERCIAL |
| Output Type | Differential |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 5.5V |
MC100EP451FA Overview
The flip flop is packaged in a case of 32-LQFP. There is an embedded version in the package Tray. Differentialis the output configured for it. It is configured with a trigger that uses Positive Edge. Surface Mountmounts this electrical part. Powered by a 3V~5.5Vvolt supply, it operates as follows. Currently, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. JK flip flop belongs to the 100EPseries of FPGAs. Its output frequency should not exceed 3GHz Hz. In total, there are 1 elements. During its operation, it consumes 135mA quiescent energy. There are 32 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. A voltage of 3.3V is used as the power supply for this D latch. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be above 3V. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V of the electronic flip flop.
MC100EP451FA Features
Tray package
100EP series
MC100EP451FA Applications
There are a lot of Rochester Electronics, LLC MC100EP451FA Flip Flops applications.
- Event Detectors
- Single Down Count-Control Line
- Divide a clock signal by 2 or 4
- QML qualified product
- Test & Measurement
- Asynchronous counter
- ESD performance
- Computers
- Synchronous counter
- Set-reset capability
