MC10E452FNG
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 28-LCC (J-Lead) |
| Number of Pins | 28 |
| Operating Temperature | 0°C~85°C TA |
| Packaging | Tube |
| Published | 2006 |
| Series | 10E |
| JESD-609 Code | e3 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 28 |
| Terminal Finish | Tin (Sn) |
| Subcategory | Shift Registers |
| Technology | ECL |
| Voltage - Supply | -4.2V~-5.7V |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 260 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | 10E452 |
| Function | Master Reset |
| Qualification Status | Not Qualified |
| Output Type | Differential |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Circuits | 2 |
| Clock Frequency | 1.1GHz |
| Propagation Delay | 850 ps |
| Turn On Delay Time | 600 ps |
| Family | 10E |
| Logic Function | D-Type |
| Output Characteristics | OPEN-EMITTER |
| Logic IC Type | D FLIP-FLOP |
| Number of Bits per Element | 5 |
| Trigger Type | Positive Edge |
| Number of Output Lines | 10 |
| Count Direction | RIGHT |
| Clock Edge Trigger Type | Positive Edge |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
MC10E452FNG Overview
The flip flop is packaged in 28-LCC (J-Lead). The Tubepackage contains it. As configured, the output uses Differential. This trigger uses the value Positive Edge. This electronic part is mounted in the way of Surface Mount. A supply voltage of -4.2V~-5.7V is required for operation. It is at 0°C~85°C TAdegrees Celsius that the system is operating. In this case, it is a type of FPGA belonging to the 10E series. There should be no greater frequency than 1.1GHzon its output. A total of 1 elements are present. A total of 28terminations have been recorded. JK flip flop belongs to 10E452 family. The power source is powered by 5V. A device of this type belongs to the family of 10E. Electronic part Surface Mountis mounted in the way. As you can see from the design, it has pins with 28. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a base part number Shift Registersfor the RS flip flops. To achieve this superior flexibility, 2 circuits are used. The JK flip flop is with 10 output lines to operate. There is a logic IC D FLIP-FLOP used in the D flip flop.
MC10E452FNG Features
Tube package
10E series
28 pins
MC10E452FNG Applications
There are a lot of ON Semiconductor MC10E452FNG Flip Flops applications.
- Patented noise
- Load Control
- Data storage
- Frequency division
- Shift Registers
- Count Modes
- ESCC
- Guaranteed simultaneous switching noise level
- Data transfer
- Latch
