MC74ACT273MG
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 20-SOIC (0.209, 5.30mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | 74ACT |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 20 |
| Type | D-Type |
| Terminal Finish | NICKEL PALLADIUM GOLD |
| Technology | CMOS |
| Voltage - Supply | 4.5V~5.5V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Supply Voltage | 5V |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| JESD-30 Code | R-PDSO-G20 |
| Function | Master Reset |
| Qualification Status | COMMERCIAL |
| Output Type | Non-Inverted |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 5.5V |
| Supply Voltage-Min (Vsup) | 4.5V |
| Clock Frequency | 200MHz |
| Family | ACT |
| Current - Quiescent (Iq) | 8μA |
| Current - Output High, Low | 24mA 24mA |
| Output Polarity | TRUE |
| Number of Bits per Element | 8 |
| Max Propagation Delay @ V, Max CL | 11ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4.5pF |
| Height Seated (Max) | 2.05mm |
| Width | 5.275mm |
| RoHS Status | ROHS3 Compliant |
MC74ACT273MG Overview
In the form of 20-SOIC (0.209, 5.30mm Width), it has been packaged. There is an embedded version in the package Tube. T flip flop uses Non-Invertedas the output. It is configured with a trigger that uses Positive Edge. Surface Mountis occupied by this electronic component. The supply voltage is set to 4.5V~5.5V. The operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. JK flip flop belongs to the 74ACTseries of FPGAs. A frequency of 200MHzshould be the maximum output frequency. The list contains 1 elements. During its operation, it consumes 8μA quiescent energy. Terminations are 20. A voltage of 5V is used to power it. A 4.5pFfarad input capacitance is provided by this T flip flop. A device of this type belongs to the family of ACT. It reaches 5.5Vwhen the maximum supply voltage (Vsup) is applied. Normally, the supply voltage (Vsup) should be above 4.5V.
MC74ACT273MG Features
Tube package
74ACT series
MC74ACT273MG Applications
There are a lot of Rochester Electronics, LLC MC74ACT273MG Flip Flops applications.
- Bus hold
- Safety Clamp
- Test & Measurement
- Set-reset capability
- CMOS Process
- Differential Individual
- Load Control
- Count Modes
- Digital electronics systems
- Single Down Count-Control Line
