MP26023DQ-LF-Z
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-VFDFN Exposed Pad |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2009 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Pin Count | 10 |
| Supply Voltage-Min (Vsup) | 3.5V |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Output Current | 1A |
| Adjustable Threshold | YES |
| Fault Protection | Over Current, Over Temperature, Over Voltage |
| Battery Chemistry | Lithium-Ion |
| Number of Cells | 1 |
| Programmable Features | Current |
| Current - Charging | Constant - Programmable |
| Charge Current - Max | 1A |
| Battery Pack Voltage | 4.2V |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MP26023DQ-LF-Z Overview
You can find it in the Tape & Reel (TR) package.For convenience, it is included in the 10-VFDFN Exposed Pad package.The mounting type of the device is Surface Mount.It is best to set the temperature to -40°C~85°C TA in order to prevent the system from overheating.It functions by using an analog IC called POWER SUPPLY SUPPORT CIRCUIT.To charge the device, a current of Constant - Programmable is required.It contains a total of 10 terminations.Battery pack voltage is 4.2V.This board has 10 pins, making it very simple to construct.Programmable features, such as Current, are available.The device has a maximum charging current of 1A.A total of 1 channels are available for use.It should be possible to run it from a 5V battery it should be able to run at all times.A supply voltage of no more than 5.5V is required for the device to operate properly.There is a constant output current of 1A when it is operating.As far as the mounting is concerned, it is mounted in the way of Surface Mount.As a rule of thumb, the supply voltage (Vsup) should be kept above 3.5V for normal operation.
MP26023DQ-LF-Z Features
Battery pack voltage of 4.2V
1 channels
10-VFDFN Exposed Pad package
MP26023DQ-LF-Z Applications
There are a lot of Monolithic Power Systems Inc. MP26023DQ-LF-Z Battery Chargers ICs applications.
- Mobile lighting
- Pallet jacks
- Energy harvesting
- Charging cradle for wearable devices
- Rental fleets
- Trash compactors
- GPS tracker
- Maintenance shops
- Electrical Utility industry
- High end, feature-rich consumer
