MP2918GF
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) Exposed Pad |
| Surface Mount | YES |
| Operating Temperature | -40°C~125°C TJ |
| Packaging | Tube |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2A (4 Weeks) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Additional Feature | REGULATING OUTPUT VOLTAGE MAX IS 25 |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G20 |
| Function | Step-Down |
| Number of Outputs | 1 |
| Output Type | PWM Signal |
| Input Voltage-Nom | 12V |
| Analog IC - Other Type | SWITCHING CONTROLLER |
| Output Configuration | Positive |
| Voltage - Supply (Vcc/Vdd) | 4V~40V |
| Control Features | Enable, Frequency Control, Power Good, Soft Start |
| Input Voltage (Min) | 4V |
| Topology | Buck |
| Control Mode | CURRENT-MODE |
| Frequency - Switching | 100kHz~1MHz |
| Input Voltage (Max) | 40V |
| Control Technique | PULSE WIDTH MODULATION |
| Synchronous Rectifier | Yes |
| Duty Cycle (Max) | 99.5% |
| Length | 6.5mm |
| Width | 4.4mm |
| RoHS Status | ROHS3 Compliant |
MP2918GF Overview
In the 20-TSSOP (0.173, 4.40mm Width) Exposed Pad package, the switching controller meets most application requirements. 1 outputs can be generated with the dc motor controller. The pmic is packaged in Tube solid enclosure. There are PWM Signal dc switching's output (s) that it can handle. dc controls with 4V~40V voltage are supplied and operated. Worked in a -40°C~125°C TJ dc switcher before. There is a switch at 100kHz~1MHz that can be used with this controller. A generalization of dc dc regulator can be made using Surface Mount. To ensure efficient switching, this dcdc regulator features a Enable, Frequency Control, Power Good, Soft Start. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. switching converters terminal (s) are designed to be at DUAL. A variety of terminations with 20 of dc switching. These dc dc converter ics adapt several control methods, including PULSE WIDTH MODULATION. A DC switcher's nominal voltage of 12V is input. It is recommended to use 4V as the minimum input voltage of dc dc voltage regulator. The dc to dc regulator can only accept a maximum input voltage of 40V. DC to DC voltage regulator has the value of REGULATING OUTPUT VOLTAGE MAX IS 25 to better satisfy the requirement.
MP2918GF Features
PWM Signal Outputs
Switching Frequency: 100kHz~1MHz
Enable, Frequency Control, Power Good, Soft Start
PULSE WIDTH MODULATION
REGULATING OUTPUT VOLTAGE MAX IS 25
MP2918GF Applications
There are a lot of Monolithic Power Systems Inc. MP2918GF DC to DC converter applications.
- Arc suppression circuits
- Photovoltaic power
- Electric heating, lighting
- Sink circuits
- Wind power
- Low output voltage switching power supply circuits
- Computer monitoring equipment of building
- Nuclear power plants
- Window air conditioners
- Packaging
