TC4013BP(N,F)
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Silver, Tin |
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 14-DIP (0.300, 7.62mm) |
| Number of Pins | 14 |
| Supplier Device Package | 14-DIP |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2012 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Voltage - Supply | 3V~18V |
| Function | Reset |
| Output Type | Differential |
| Number of Elements | 2 |
| Polarity | Non-Inverting |
| Max Supply Voltage | 18V |
| Min Supply Voltage | 3V |
| Clock Frequency | 20MHz |
| Quiescent Current | 4μA |
| Logic Function | D-Type |
| Current - Quiescent (Iq) | 120μA |
| Current - Output High, Low | 3.4mA 3.4mA |
| Number of Bits per Element | 1 |
| Max Propagation Delay @ V, Max CL | 90ns @ 15V, 50pF |
| Trigger Type | Positive Edge |
| High Level Output Current | -4mA |
| Input Capacitance | 5pF |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
TC4013BP(N,F) Overview
The flip flop is packaged in 14-DIP (0.300, 7.62mm). As part of the package Tube, it is embedded. The output it is configured with uses Differential. In the configuration of the trigger, Positive Edgeis used. Through Holemounts this electrical part. A voltage of 3V~18Vis required for its operation. In the operating environment, the temperature is -40°C~85°C TA. D-Typedescribes this flip flop. This D flip flop should not have a frequency greater than 20MHz. In total, there are 2 elements. As a result, it consumes 120μA quiescent current. The input capacitance of this JK flip flopis 5pF farads. A part of the electronic system is mounted in the way of Through Hole. There are 14pins on it. It consumes 4μA of quiescent current without being affected by external factors. -4mAis the output current at high level. If the operating temperature is lower than 85°C, it is recommended. The operating temperature should be higher than -40°C. It is powered by 3V as its minimum supply voltage. There is a maximum supply voltage of 18V.
TC4013BP(N,F) Features
Tube package
14 pins
TC4013BP(N,F) Applications
There are a lot of Toshiba Semiconductor and Storage TC4013BP(N,F) Flip Flops applications.
- Guaranteed simultaneous switching noise level
- Circuit Design
- Digital electronics systems
- Synchronous counter
- Load Control
- Buffered Clock
- Shift registers
- Modulo – n – counter
- 2 – Bit synchronous counter
- Functionally equivalent to the MC10/100EL29
