VNP10N07FI-E
| Parameters | |
|---|---|
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | ISOWATT-220-3 |
| Number of Pins | 3 |
| Supplier Device Package | ISOWATT-220 |
| Packaging | Tube |
| Series | OMNIFET™, VIPower™ |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Resistance | 100mOhm |
| Max Power Dissipation | 50W |
| Base Part Number | VNP10N |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 7A |
| Operating Supply Voltage | 18V |
| Interface | On/Off |
| Current - Output (Max) | 7A |
| Nominal Supply Current | 250μA |
| Output Configuration | Low Side |
| Power Dissipation | 50W |
| Output Current | 7A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 250μA |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Continuous Drain Current (ID) | 10A |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 55V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Drain to Source Breakdown Voltage | 70V |
| Rds On (Typ) | 100mOhm (Max) |
| Drain to Source Resistance | 100mOhm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
VNP10N07FI-E Overview
Tube is the way it's packaged.In the ISOWATT-220-3 package, it is included.This lighting drivere has a mounting type of Through Hole.This switch is of type General Purpose.In this LED driver, there are no outputs available.With a supply voltage of Not Required, the LED driving board operates.The maximum output voltage of this LED driver is N-Channel volts.As you can see, it comes from the VNP10N family.In order to operate, 3 pins are used.There is a maximum output of 7AV from the LED driver.The maximum output current is reduced to 7A to meet the operation criteria.Through Hole is mounted in the way of this lighting driver.100mOhm resistance is present in the lighting driver.These electrical components are part of the OMNIFET?, VIPower? series.As a result, the output current is set to 7A.It is recommended that the supply voltage be set at 18V in order to achieve maximum efficiency.It has a maximum current requirement of 250μA.
VNP10N07FI-E Features
Resistance of 100mOhm
VNP10N07FI-E Applications
There are a lot of STMicroelectronics VNP10N07FI-E Power Switches ICs applications.
- Portable GPS Device
- Various applications equipped with buttons
- Wearable Devices
- Hot Swap
- Portable Devices
- Hot Swap
- Wireless Modem Data Cards
- Notebook PC
- Notebook and Tablet Computers
- PC Cards
