ADG1208YRUZ-REEL7
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | PRODUCTION (Last Updated: 1 month ago) |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 200Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 4.7mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG1208 |
| Pin Count | 16 |
| Operating Supply Voltage | 12V |
| Number of Channels | 8 |
| Interface | Parallel |
| Number of Circuits | 1 |
| Max Supply Voltage | 16.5V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 220μA |
| Nominal Supply Current | 320μA |
| Power Dissipation | 4.7mW |
| Logic Function | Multiplexer |
| Number of Inputs | 8 |
| Voltage - Supply, Single/Dual (±) | 5V~16.5V ±5V~16.5V |
| Supply Type | Dual, Single |
| Bandwidth | 550MHz |
| Supply Current-Max (Isup) | 0.33mA |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 83 ns |
| Max Dual Supply Voltage | 16.5V |
| On-State Resistance (Max) | 200Ohm |
| Min Dual Supply Voltage | 5V |
| Dual Supply Voltage | 15V |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 85 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 1.5pF 7pF |
| On-state Resistance Match-Nom | 3.5Ohm |
| Switch Time (Ton, Toff) (Max) | 95ns, 100ns |
| Charge Injection | 0.4pC |
| Channel-to-Channel Matching (ΔRon) | 3.5 Ω |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Signal Current-Max | 0.03A |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
ADG1208YRUZ-REEL7 Overview
Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 8:1. An extended operating temperature of -40°C~125°C TA degrees Celsius. Total terminations are 16. The electronic part provides high-quality output because it has 8 channels. A 15V voltage supply should turn on and run the electronic component. A total of 16 pins are injected into the body of the electronic part. A total of 1 circuits make up this switch device. Look for analog switch ic variants by searching with ADG1208. It has an internal resistance of 200Ohm. Datasheets for 16 pin functions are available upon request. Multiplexers should not be powered above 16.5V in normal situations. Dual, Single supply type digital switch with a low cost. 5V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 220μA current would be sufficient. Despite this switch's dual supply capability, its voltage should not exceed 16.5V. The voltage should be at least 5V if you are using dual power supplies. 12V operating voltages are supported by the electronic component. It is possible to operate 8 inputs. It is possible to transfer data over a 550MHz-bandwidth.
ADG1208YRUZ-REEL7 Features
8 Channels
220μA Supply Current
Bandwidth: 550MHz
ADG1208YRUZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG1208YRUZ-REEL7 Analog Switches & Multiplexers ICs applications.
- Remote wireless modules
- Cable Modem
- Channel Banks
- Battery Powered Systems
- Cell phones
- Audio and video signal routing
- Optical Applications
- Medical systems
- DSLAMs
- Voice over IP/DSL – Integrated Access Devices, Smart
