BD82029FVJ-GE2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2014 |
| Feature | Slew Rate Controlled, Status Flag |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 90mOhm |
| Max Power Dissipation | 580mW |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | BD82029 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 600mA |
| Operating Supply Voltage | 5V |
| Interface | On/Off |
| Analog IC - Other Type | SPST |
| Output Configuration | High Side |
| Output Current | 600mA |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Turn On Delay Time | 500 μs |
| Switch Type | USB Switch |
| Turn-Off Delay Time | 4 μs |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 4.5V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Rds On (Typ) | 72m Ω |
| RoHS Status | ROHS3 Compliant |
BD82029FVJ-GE2 Overview
As a result, it is packaged in the form of a Tape & Reel (TR).It is included in the package 8-TSSOP, 8-MSOP (0.118, 3.00mm Width).This LED driving board is mounted using the mounting type Surface Mount.USB Switch is the switch type that it owns.The temperature should be set to -40°C~85°C TA to ensure reliable functioning.It is possible to use 1 outputs in the lighting driver.The LED driving board is powered by a voltage of Not Required.There is a maximum output voltage of N-Channel volts.As far as features are concerned, the LED driving board has Slew Rate Controlled, Status Flag.There is a BD82029 family of things that it belongs to.For operation, 8 pins are used.The maximum output current must drop to 600mA to meet the operation criteria.This lighting driver is mounted in the way of Surface Mount.It has 90mOhm resistance.When this is the case, the output current is set to 600mA.In this case, the analog IC is SPST.When using this LED driving board, it is recommended that the supply voltage is set to 5V.
BD82029FVJ-GE2 Features
Resistance of 90mOhm
BD82029FVJ-GE2 Applications
There are a lot of ROHM Semiconductor BD82029FVJ-GE2 Power Switches ICs applications.
- USB Power Distribution
- Handheld Devices
- PC Card Hot Swap
- Notebook PC
- USB3.1 Power Delivery
- Solid-State Drives
- Smart Phones, Feature Phones
- Storage (HDDs, SSDs)
- Hot Swaps
- Wearable Devices
