BTS142DATMA1
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | TO-252-3, DPak (2 Leads + Tab), SC-63 |
| Surface Mount | YES |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2007 |
| Series | HITFET® |
| JESD-609 Code | e3 |
| Feature | Auto Restart |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 2 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin (Sn) |
| Technology | MOS |
| Terminal Position | SINGLE |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Terminal Pitch | 2.28mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | BTS142 |
| Pin Count | 4 |
| JESD-30 Code | R-PSSO-G2 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Type | N-Channel |
| Interface | On/Off |
| Current - Output (Max) | 4.6A |
| Output Configuration | Low Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 42V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Output Peak Current Limit-Nom | 45A |
| Rds On (Typ) | 23m Ω |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL |
| Output Current Flow Direction | SINK |
| Height Seated (Max) | 2.5mm |
| Length | 6.5mm |
| Width | 6.22mm |
| RoHS Status | ROHS3 Compliant |
BTS142DATMA1 Overview
It's?packaged?in?the way?of?a?Tape & Reel (TR).The TO-252-3, DPak (2 Leads + Tab), SC-63 package contains it.The LED driver is mounted as Surface Mount.General Purpose is the switch type it owns.It is best to set the temperature to -40°C~150°C TJ to ensure reliable operation.The lighting driver has a total of 1 outputs that are available for use.Operation is based on a supply voltage of Not Required.A maximum output voltage of N-Channel volts can be achieved by this LED driver.In terms of features, the LED driving board has Auto Restart.It belongs to the BTS142 family.A total of 2 terminations have been recorded.It is important to note that the LED driving board has 1 functions.From the lighting driver, there is a maximum output of 4.6AV.High efficiency is possible at 12V supply voltage.4 pins are equipped with it.It is part of the HITFET? series.
BTS142DATMA1 Features
Supplied from 12V
BTS142DATMA1 Applications
There are a lot of Infineon Technologies BTS142DATMA1 Power Switches ICs applications.
- Portable GPS
- Hard Disk Drives
- Notebook and Tablet Computers
- USB Power Distribution
- Storage Drives
- HDD and SSD
- Smartphone and PDA
- Gaming
- Hot Swaps
- Storage (HDDs, SSDs)
