BTS500251TADATMA1
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | TO-263-7, D2Pak (6 Leads + Tab), TO-263CB |
| Surface Mount | YES |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2017 |
| Series | Automotive, AEC-Q100, Reversave™ |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Terminal Position | SINGLE |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 13.5V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PSSO-G6 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Supply Voltage-Min (Vsup) | 8V |
| Interface | On/Off |
| Current - Output (Max) | 25A |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 8V~18V |
| Fault Protection | Over Temperature, Over Voltage, Reverse Battery, Short Circuit |
| Turn On Time | 550 μs |
| Output Peak Current Limit-Nom | 30A |
| Rds On (Typ) | 3.9m Ω |
| Turn Off Time | 550 μs |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Height Seated (Max) | 4.5mm |
| Width | 9.25mm |
| RoHS Status | Non-RoHS Compliant |
BTS500251TADATMA1 Overview
It is packaged in the form of a Tape & Reel (TR).It's included in the TO-263-7, D2Pak (6 Leads + Tab), TO-263CB package.This LED driving board is mounted using the mounting type Surface Mount.A General Purpose switch type is owned by it.In order to guarantee reliable performance, the temperature should be set to -40°C~150°C TJ.The LED driver is equipped with 1 outputs.The LED driving board operates at Not Required volts.There is a maximum output voltage of N-Channel volts on this LED driver.The termination count is 6.It contains 1 functions.Its maximum output voltage is 25AV.The supply voltage can be 13.5V for high efficiency.It is included in the Automotive, AEC-Q100, Reversave? series.In order to operate normally, the supply voltage (Vsup) must remain above 8V.
BTS500251TADATMA1 Features
Supplied from 13.5V
BTS500251TADATMA1 Applications
There are a lot of Infineon Technologies BTS500251TADATMA1 Power Switches ICs applications.
- Set-Top Boxes
- Wearable Devices
- Smart Phones, Feature Phones
- PC Card Hot Swap
- Wireless Modem Data Cards
- Portable GPS Device
- Set-top-box
- USB Ports/Hubs
- PDAs
- USB Power Distribution
