CY2309ZXC-1HT
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Gold, Tin |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C |
| Packaging | Tape & Reel (TR) |
| Published | 2005 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| Type | Fanout Buffer (Distribution), Zero Delay Buffer |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Clock Drivers |
| Voltage - Supply | 3V~3.6V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.65mm |
| Frequency | 133.33MHz |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | CY2309 |
| Output | LVCMOS |
| Pin Count | 16 |
| Number of Outputs | 9 |
| Operating Supply Voltage | 3.3V |
| Supply Voltage-Max (Vsup) | 3.6V |
| Supply Voltage-Min (Vsup) | 3V |
| Number of Circuits | 1 |
| Nominal Supply Current | 32mA |
| Input | LVCMOS, LVTTL |
| Ratio - Input:Output | 1:9 |
| Max I(ol) | 0.008 A |
| PLL | Yes with Bypass |
| Differential - Input:Output | No/No |
| Propagation Delay (tpd) | 8.7 ns |
| Same Edge Skew-Max (tskwd) | 0.25 ns |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
CY2309ZXC-1HT Overview
Clock generator is packaged in the way of Tape & Reel (TR). The 16-TSSOP (0.173, 4.40mm Width) package contains this clock generator. Frequency generator is capable of operating at a maximum temperature of 260 when reflowing. It contains a total of 16 terminations within RF synthesizer. This time clock generator should be voltaged at 3.3V. This Clock PLL will be fed by LVCMOS, LVTTL as its input. For full access to the electronic component's capabilities, 1 circuits are implemented. Because of the Surface Mount, clock PLL can be easily mounted on the panel. The maximal supply voltage (Vsup) reaches 3.6V. It is safe to use this frequency synthesizer with a supply voltage above 3V. As far as the supply voltage is concerned, clock PLL can be used with 3V~3.6V. The temperature should be set at 0°C~70°C to ensure reliable performance. The RF synthesizer is compatible with LVCMOS logic levels. This electronic component is usually classified as a Fanout Buffer (Distribution), Zero Delay Buffer component. There is a 16-bit clock-generating IC built specifically for microprocessors in this frequency generator. According to the base part number, its related parts can be founded. A 16 pin is available on the clock PLL. The supply voltage should be maintained at 3.3V for high efficiency. Clock generator can also be included into Clock Drivers. Clock PLL is facilitated with 9 signal outputs to magnify output frequency as high as possible. Low timing skew is provided by this analog clock generator at maximum 0.25 ns. By operating at a frequency of 133.33MHz, RF synthesizer is able to reali133.33MHze high efficiency.
CY2309ZXC-1HT Features
Available in the 16-TSSOP (0.173, 4.40mm Width)
Supply voltage of 3.3V
Operating supply voltage of 3.3V
CY2309ZXC-1HT Applications
There are a lot of Cypress Semiconductor Corp CY2309ZXC-1HT Clock Generators applications.
- Precision auxiliary angle deflection measurement
- Microwave backhaul IF
- Threshold extension
- Microwave radio
- Radio receivers
- Cable television converter boxes
- Carrier synchronization in wired communication
- Local oscillators (LOs)
- Radar
- Modems
