DG613DJ
| Parameters | |
|---|---|
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Number of Pins | 16 |
| Weight | 1.627801g |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2009 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Resistance | 45Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 470mW |
| Number of Functions | 4 |
| Pin Count | 16 |
| Number of Outputs | 4 |
| Number of Circuits | 1 |
| Max Supply Voltage | 18V |
| Min Supply Voltage | 10V |
| Analog IC - Other Type | SPST |
| Power Dissipation | 470mW |
| Max Supply Current | 1μA |
| Turn On Delay Time | 35 ns |
| Voltage - Supply, Single/Dual (±) | 10V~18V ±10V~15V |
| Supply Type | Dual, Single |
| Bandwidth | 500MHz |
| Turn-Off Delay Time | 25 ns |
| Max Dual Supply Voltage | 15V |
| On-State Resistance (Max) | 45Ohm |
| Min Dual Supply Voltage | 10V |
| Multiplexer/Demultiplexer Circuit | 2:2 |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 3pF 2pF |
| Switch Circuit | DPDT |
| Switch Time (Ton, Toff) (Max) | 35ns, 25ns |
| Charge Injection | 4pC |
| Channel-to-Channel Matching (ΔRon) | 2 Ω |
| Crosstalk | -87dB @ 10MHz |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 45Ohm |
| Height | 3.81mm |
| Length | 21.33mm |
| Width | 7.11mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | Non-RoHS Compliant |
DG613DJ Overview
The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. High reliability is provided by advanced packaging method Tube. Through Hole is where this multiplexer is located. 2:2 is the ratio between multiplexers and demultiplexers. Around -40°C~85°C TA is the extended operating temperature. Totally, there are 16 terminations. This electrical component is included in the 16 series of products. DPDT switching circuits are used in these analog switch ics. Circuits number 1 make up this analogue multiplexer. Internally, this switch multiplexer has a resistance of 45Ohm. Datasheets for 16 pin functions are available upon request. It is a typical Multiplexer or Switches analog multiplexer. normally, users should not supply switches with voltages higher than 18V. Dual, Single supply type digital switch with a low cost. 10V is the lowest voltage that should be fed to the electronic electronic part. A voltage higher than 1μA may cause damage to the switch multiplexer. Despite this switch's dual supply capability, its voltage should not exceed 15V. If you are using a dual power supply, you should attach at least 10V. It is integrated with a SPST analog IC. There are various bandwidths available for data transfer. Drain to Source resistance is 45Ohm. There are 4 outputs on the analogue multiplexer.
DG613DJ Features
Switch Circuit: DPDT
Bandwidth: 500MHz
Drain-to-Source resistance: 45Ohm
DG613DJ Applications
There are a lot of Vishay Siliconix DG613DJ Analog Switches & Multiplexers ICs applications.
- Cable Modem
- Modems
- High-Voltage
- Isolation
- MP3 players
- Power routing
- Automotive applications
- Intelligent PBX
- Audio signal routing
- Sample-and-hold systems
