EL5165IWZ-T7A
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | SOT-23 |
| Number of Pins | 5 |
| Packaging | Cut Tape |
| Published | 2003 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Pin Count | 5 |
| Operating Supply Voltage | 9V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 3.5mA |
| Nominal Supply Current | 4.2mA |
| Slew Rate | 4700 V/μs |
| Common Mode Rejection Ratio | 62 dB |
| Current - Input Bias | 2μA |
| Output Current per Channel | 190mA |
| Input Offset Voltage (Vos) | 1.5mV |
| Bandwidth | 600000 kHz |
| Power Supply Rejection Ratio (PSRR) | 79dB |
| Max Dual Supply Voltage | 6V |
| -3db Bandwidth | 600MHz |
| Min Dual Supply Voltage | 2.5V |
| Consumer IC Type | VIDEO AMPLIFIER |
| Length | 2.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
EL5165IWZ-T7A Overview
The linear amplifier is packaged in a SOT-23 case which makes it easy for the consumer to handle. In the case of Cut Tape cases, linear amplifier will be delivered. It is estimated that there will be at least 5 terminations this year. It consists of a total of 5 pins in total. 5 pins are included on the operational amplifiers. Op amp ic rates 1.5mV for input offset voltage. In order for this instrumentation amplifier to operate, the supply current needs to be between 3.5mA and 10 . The op amp ic has 1 channels on it. The temperature should not be lower than -40°C for operational amplifier ics to operate. It is recommended that op amp be used at temperatures below 85°C. The operating supply voltage of the buffer op amp is rated at 9V. It is important to keep in mind that the power supply voltage of this electric component is below 12V, which is suitable. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 5V when using it. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 6V volts. In order to sort customer IC types, use VIDEO AMPLIFIER.
EL5165IWZ-T7A Features
5 Pins
EL5165IWZ-T7A Applications
There are a lot of Intersil (Renesas Electronics America) EL5165IWZ-T7A Instrumentational OP Amps applications.
- E-book readers
- Laptop
- Multimedia playback equipment
- Semiconductor detectors
- Division circuits
- High speed sample
- Navigation
- Power control
- Test equipment
- MP3
