HI4P0201-5Z
| Parameters | |
|---|---|
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 1.27mm |
| Output | SEPARATE OUTPUT |
| Pin Count | 20 |
| Power Supplies | +-15V |
| Temperature Grade | COMMERCIAL EXTENDED |
| Number of Channels | 1 |
| Max Supply Voltage | 44V |
| Operating Supply Current | 500μA |
| Nominal Supply Current | 500μA |
| Max Supply Current | 2mA |
| Number of Bits | 4 |
| Throw Configuration | SPST |
| Turn On Delay Time | 185 ns |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 220 ns |
| Max Dual Supply Voltage | 22V |
| Off-state Isolation-Nom | 80 dB |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Length | 8.965mm |
| Width | 8.965mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 20 |
| Packaging | Bulk |
| Published | 1999 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 20 |
| Resistance | 80Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Max Operating Temperature | 75°C |
| Min Operating Temperature | 0°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
HI4P0201-5Z Overview
The electronic component is convenient to ship overseas because it is packed in a PLCC. A high level of reliability can be achieved through the use of an advanced packaging method Bulk. In total, there are 20 terminations. A electrical component with 1 channels is capable of high-quality output. Turning on and running the electrical part should be easy with a 15V voltage supply. 20 pins are injected to the electronic part body. As far as internal resistance is concerned, it has 80Ohm. The datasheets for the 20 pins explain the functions. There is a standard Multiplexer or Switches analogue multiplexer here. It is normally recommended that users do not supply the multiplexer with voltages higher than 44V. Analog switch ics with Dual, Single supply type are cost-effective. The switch device would be able to operate with 500μA current. Put voltage above 2mA on the multiplexer to cause damage. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Temperatures above 75°C should not be used to operate the switches. 4-bit conductivity is possible.
HI4P0201-5Z Features
1 Channels
500μA Supply Current
4-Bit
HI4P0201-5Z Applications
There are a lot of Intersil (Renesas Electronics America) HI4P0201-5Z Analog Switches & Multiplexers ICs applications.
- Battery-powered systems
- Digital cross connects (DSX-1)
- E1 Multiplexer
- SONET
- PCMCIA cards
- DSUs
- High speed data transmission line cards
- Private Branch Exchange (PBX)
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Sample hold systems
