IDT74FCT2374ATQG
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SSOP |
| Number of Pins | 20 |
| Published | 2009 |
| JESD-609 Code | e3 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | FF/Latches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.635mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 20 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Load Capacitance | 50pF |
| Number of Ports | 2 |
| Number of Bits | 8 |
| Propagation Delay | 6.5 ns |
| Turn On Delay Time | 2 ns |
| Family | FCT |
| Output Characteristics | 3-STATE WITH SERIES RESISTOR |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | 12mA |
| Low Level Output Current | 15mA |
| Clock Edge Trigger Type | Positive Edge |
| Width | 3.937mm |
| RoHS Status | RoHS Compliant |
IDT74FCT2374ATQG Overview
The flip flop is packaged in a case of SSOP. In total, it contains 1 elements. A total of 20 terminations have been made. An input voltage of 5Vpowers the D latch. An electronic device belonging to the family FCTcan be found here. There is an electronic part that is mounted in the way of Surface Mount. 20pins are included in its design. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchesfor the RS flip flops. This flip flop is designed with 8 Bits. The D latch runs on a voltage of 5V volts. The D flip flop has no ports embedded. In order to ensure high efficiency, the supply voltage should remain at 5V. 12mAis the output current at high level. In the low level output current setting, the current is set to 15mA. The operating temperature should be lower than 85°C. It is recommended that the operating temperature is higher than -40°C. It is powered by 4.75V as its minimum supply voltage. In this case, it supports a maximum supply voltage of 5.25V. It uses a logic IC with a BUS DRIVER value. It has 1 functions. It is equipped with 20 pin count.
IDT74FCT2374ATQG Features
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
IDT74FCT2374ATQG Applications
There are a lot of Integrated Device Technology (IDT) IDT74FCT2374ATQG Flip Flops applications.
- Count Modes
- Latch-up performance
- Shift Registers
- QML qualified product
- Synchronous counter
- ESD performance
- Frequency division
- ATE
- Load Control
- Instrumentation
