MAX4522ESE

80ns, 30ns SPST - NO 100Ohm Analog Switches BREAK-BEFORE-MAKE MAX4522 16 Pins 1nA 5V 16-SOIC (0.154, 3.90mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-MAX4522ESE
Package: 16-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 396
Description: 80ns, 30ns SPST - NO 100Ohm Analog Switches BREAK-BEFORE-MAKE MAX4522 16 Pins 1nA 5V 16-SOIC (0.154, 3.90mm Width)(Kg)

Details

Tags

Parameters
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.154, 3.90mm Width)
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2007
JESD-609 Code	e0
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	100Ohm
Terminal Finish	Tin/Lead (Sn85Pb15)
Additional Feature	ALSO OPERATE WITH 2V TO 12V SINGLE SUPPLY
Subcategory	Multiplexer or Switches
Max Power Dissipation	696mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	240
Number of Functions	4
Supply Voltage	5V
Terminal Pitch	1.27mm
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	MAX4522
Output	SEPARATE OUTPUT
Pin Count	16
JESD-30 Code	R-PDSO-G16
Operating Supply Voltage	5V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	12V
Min Supply Voltage	2V
Operating Supply Current	1μA
Nominal Supply Current	1μA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	100 ns
Voltage - Supply, Single/Dual (±)	2V~12V ±2V~6V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-5V
Turn-Off Delay Time	40 ns
Max Dual Supply Voltage	6V
On-State Resistance (Max)	100Ohm
Min Dual Supply Voltage	2V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	90 dB
Current - Leakage (IS(off)) (Max)	1nA
Channel Capacitance (CS(off), CD(off))	2pF 2pF
On-state Resistance Match-Nom	1Ohm
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	80ns, 30ns
Charge Injection	1pC
Channel-to-Channel Matching (ΔRon)	1 Ω
Crosstalk	-90dB @ 100kHz
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	80ns
Switch-off Time-Max	30ns
Normal Position	NO
Height Seated (Max)	1.75mm
Length	9.9mm
Width	3.9mm
Radiation Hardening	No
RoHS Status	Non-RoHS Compliant
Lead Free	Contains Lead

MAX4522ESE Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). In order to provide high reliability, an advanced packaging method Tube is used. The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Around -40°C~85°C TA is the extended operating temperature. There are 16 terminations totally. A high-quality output is provided by the electrical component's 1 channels. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. A total of 16 pins are injected into the electrical part body. These analog multiplexers are built based on SPST - NO switching circuits. The circuits in this analogue multiplexer number 4. Try searching with MAX4522 if you're looking for variants. Analog switches have 100Ohm internal resistance. This switch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 12V. The analog switch ic is of the Dual, Single supply type and is cost-effective. There should be 2V voltage fed to the electrical part below 2V. An operating current of 1μA would be sufficient for this switch device. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 6V. In the case of dual power supplies, you should connect at least 2V. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Operating voltages range from 5V. Additional features of the electronic component include: ALSO OPERATE WITH 2V TO 12V SINGLE SUPPLY.