MAX4580CWE
| Parameters | |
|---|---|
| Switch Time (Ton, Toff) (Max) | 160ns, 210ns |
| Charge Injection | -60pC |
| Channel-to-Channel Matching (ΔRon) | 500m Ω |
| Crosstalk | -65dB @ 1MHz |
| Normal Position | NC |
| Length | 10.3mm |
| Width | 7.5mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 2003 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.25Ohm |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 571mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4580 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 20V |
| Power Supplies | 5/30/+-5/+-15V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 4.5V |
| Nominal Supply Current | 5μA |
| Max Supply Current | 500nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 210 ns |
| Voltage - Supply, Single/Dual (±) | 4.5V~36V ±4.5V~20V |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 160 ns |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 1.25Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 53 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 115pF |
| On-state Resistance Match-Nom | 0.05Ohm |
| Switch Circuit | SPST - NC |
MAX4580CWE Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.295, 7.50mm Width). High reliability is provided by advanced packaging method Tube. There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature around 0°C~70°C TA extended. Total terminations are 16. Due to its 1 channels, the electrical component produces high-quality output. If the voltage supply is 15V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. Multiplexers built on a SPST - NC switching circuit are built. There are 2 circuits in this multiplexer. Using the MAX4580 search parameter, you can discover variants of the switch. The internal resistance of this digital multiplexer is 1.25Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. A cost-effective Dual, Single supply type analogue multiplexer. A low voltage of 4.5V should be applied to the electronic component. A voltage higher than 500nA may cause damage to the switch multiplexer. Despite this switch device's dual supply capability, its voltage should not exceed 20V. For dual power supplies, a voltage of at least 4.5V should be attached. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. 20V operating voltages can be used with this electrical part.
MAX4580CWE Features
1 Channels
Switch Circuit: SPST - NC
MAX4580CWE Applications
There are a lot of Maxim Integrated MAX4580CWE Analog Switches & Multiplexers ICs applications.
- Audio signal routing
- Channel Banks
- E1 Multiplexer
- ISDN NT1/TA
- Private Branch Exchange (PBX)
- Wireless Local Loop
- Relay replacements
- Ultrasound
- High speed data transmission line cards
- FTTH
