Parameters |
Factory Lead Time |
1 Week |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
20-WQFN Exposed Pad |
Number of Pins |
20 |
Operating Temperature |
-40°C~85°C |
Packaging |
Tape & Reel (TR) |
Published |
2006 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
20 |
ECCN Code |
EAR99 |
Type |
PLL Clock Generator |
Terminal Finish |
Matte Tin (Sn) |
Voltage - Supply |
3V~3.6V |
Terminal Position |
QUAD |
Peak Reflow Temperature (Cel) |
260 |
Supply Voltage |
3.3V |
Terminal Pitch |
0.65mm |
Time@Peak Reflow Temperature-Max (s) |
40 |
Base Part Number |
MAX9491 |
Output |
LVCMOS |
Pin Count |
20 |
Operating Supply Voltage |
3.3V |
Number of Circuits |
1 |
Frequency (Max) |
200MHz |
Input |
LVCMOS, Crystal |
Ratio - Input:Output |
1:1 |
Primary Clock/Crystal Frequency-Nom |
27MHz |
PLL |
Yes |
Differential - Input:Output |
No/No |
Height Seated (Max) |
0.8mm |
Length |
5mm |
Width |
5mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
MAX9491ETP080+T Overview
As a clock IC, PLLs is packaged using the Tape & Reel (TR) method. Clock PLL is embedded in the 20-WQFN Exposed Pad package. A maximum temperature of 260 can be sustained by this clock generator ic during reflowing. As you can see, it consists of 20 terminations. To operate this time clock generator, 3.3V voltage should be applied. It is designed that the Clock PLL's input should be LVCMOS, Crystal. It is possible to access the full performance of the electrical part by implementing 1 circuits. It provides a maximum frequency of 200MHz. PLL clock is mounted in the way of Surface Mount. There are 3V~3.6V different supply voltages that can be provided for this RF synthesizer. The ambient temperature should be set at -40°C~85°C, which is estimated by the test statistics. LVCMOS logic levels are supported by this RF synthesizer. An electrical part such as this one can be classified as a PLL Clock Generator component. It is a 20-bit IC that is designed for microprocessors specifically. The related electronic parts of part number MAX9491 are listed below. It is possible to connect to the frequency generators via 20 pins. The maximum supply voltage that clock generator can handle is 3.3V.
MAX9491ETP080+T Features
Available in the 20-WQFN Exposed Pad
Supply voltage of 3.3V
Operating supply voltage of 3.3V
MAX9491ETP080+T Applications
There are a lot of Maxim Integrated MAX9491ETP080+T Clock Generators applications.
- Coherent carrier tracking
- Phase modulation cellular systems
- Small signal recovery
- Ports
- Precision auxiliary angle deflection measurement
- Broadcast communication
- Myriad digital applications
- High-frequency induction heating
- Local oscillator source in receiver
- Quenching?