SN74AHC4066PWRE4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 14 |
| Weight | 57.209338mg |
| Packaging | Tape and Reel |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 14 |
| Resistance | 75Ohm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 2.3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output | SEPARATE OUTPUT |
| Pin Count | 14 |
| Qualification Status | Not Qualified |
| Power Supplies | 2.5/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2V |
| Max Supply Current | 20μA |
| Throw Configuration | SPST |
| Propagation Delay | 4 ns |
| Turn On Delay Time | 25 ns |
| Number of Inputs | 4 |
| Supply Type | Single |
| Bandwidth | 50MHz |
| Turn-Off Delay Time | 25 ns |
| Off-state Isolation-Nom | 40 dB |
| On-state Resistance Match-Nom | 6Ohm |
| Normal Position | NO |
| Height Seated (Max) | 1.2mm |
| Length | 5mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
SN74AHC4066PWRE4 Overview
Presented in TSSOP, this electrical component is convenient for overseas shipping. High reliability is provided by advanced packaging method Tape and Reel. Total terminations are 14. A high-quality output is provided by the electrical component's 1 channels. If the voltage supply is 2.3V volts, the electrical component should be turned on and run. An injection of 14 pins is performed into the body of the electrical component. An switch multiplexer with 75Ohm internal resistance has a value of 75Ohm. The functions of 14 pins can be found in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. normally, users should not supply switches with voltages higher than 5.5V. Digital switch that provides Single power at a cost-effective price. A low voltage of 2V should be applied to the electronic component. The switch multiplexer may be damaged if it is exposed to voltage greater than 20μA. There are SEPARATE OUTPUT outputs on this analog switch ic. It is possible to operate 4 inputs. It is possible to transfer data over a 50MHz-bandwidth. An environment with a temperature greater than 85°C should not be used to operate the digital switches.
SN74AHC4066PWRE4 Features
1 Channels
Bandwidth: 50MHz
SN74AHC4066PWRE4 Applications
There are a lot of Texas Instruments SN74AHC4066PWRE4 Analog Switches & Multiplexers ICs applications.
- Relay replacements
- RGB switches
- Access Concentrators
- SONET/SDH ADM
- DSLAMs
- Industrial
- Audio signal routing
- Multiplexers
- PCMCIA cards
- Cellular phones
