TCK112G,LF
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-UFBGA, WLCSP |
| Number of Pins | 6 |
| Weight | 1.700971mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2014 |
| Feature | Load Discharge, Slew Rate Controlled |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Resistance | 15mOhm |
| Max Power Dissipation | 1.2W |
| Technology | CMOS |
| Terminal Position | BOTTOM |
| Terminal Form | BALL |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 3A |
| Supply Voltage-Max (Vsup) | 5.5V |
| Interface | On/Off |
| Output Configuration | High Side |
| Output Current | 3A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Turn On Delay Time | 200 μs |
| Switch Type | General Purpose |
| Turn-Off Delay Time | 4 μs |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 1.1V~5.5V |
| Fault Protection | Over Temperature, Reverse Current |
| Rds On (Typ) | 8.3m Ω |
| Built-in Protections | TRANSIENT; THERMAL |
| Height Seated (Max) | 0.54mm |
| RoHS Status | RoHS Compliant |
TCK112G,LF Overview
A Cut Tape (CT) is used to package it.It's included in the 6-UFBGA, WLCSP package.Surface Mount is the mounting type of the LED driver.General Purpose is the switch type it owns.The temperature should be set to -40°C~85°C TA to ensure reliable functioning.The lighting driver has a total of 1 outputs that are available for use.The LED driving board is powered by a voltage of Not Required.A maximum voltage of N-Channel volts is available from the output of this LED driver.Currently, the LED driving board is equipped with Load Discharge, Slew Rate Controlled features.It has a total of 6 terminations.In order to operate, 6 pins are used.Currently, the lighting driver has a total of 1 functions.This operation requires the maximum output current to be decreased to 3A.With a supply voltage of 1.8V, high efficiency is possible.As a result, it is mounted in the manner of Surface Mount.15mOhm resistance is present in the lighting driver.The output current is set to 3A in this case.The maximum supply voltage for this LED driver is 5.5V (Vsup).
TCK112G,LF Features
Supplied from 1.8V
Resistance of 15mOhm
TCK112G,LF Applications
There are a lot of Toshiba Semiconductor and Storage TCK112G,LF Power Switches ICs applications.
- Smart Phones, Feature Phones
- Hot Swap
- Handheld Devices
- USB Protection
- Solid State Drivers
- Various applications equipped with buttons
- Hot Swaps
- Wearable Devices
- USB3.1 Power Delivery
- Low Voltage I/O System Power
