5962-9313101MPA
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Contact Plating | Lead, Tin |
| Package / Case | Q |
| Surface Mount | NO |
| Number of Pins | 8 |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Subcategory | Operational Amplifier |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Number of Functions | 1 |
| Terminal Pitch | 2.54mm |
| Base Part Number | AD811 |
| Pin Count | 8 |
| Number of Elements | 1 |
| Temperature Grade | MILITARY |
| Max Supply Voltage | 18V |
| Quiescent Current | 16mA |
| Slew Rate | 2500 V/μs |
| Architecture | CURRENT-FEEDBACK |
| Amplifier Type | OPERATIONAL AMPLIFIER |
| Common Mode Rejection Ratio | 50 dB |
| Input Offset Voltage (Vos) | 500μV |
| Unity Gain BW-Nom | 1000000 kHz |
| Power Supply Rejection Ratio (PSRR) | 60dB |
| Low-Offset | NO |
| Frequency Compensation | YES |
| Max Dual Supply Voltage | 18V |
| Low-Bias | NO |
| Micropower | NO |
| Min Dual Supply Voltage | 4.5V |
| Programmable Power | NO |
| Input Bias Current | 2μA |
| Wideband | YES |
| Input Voltage Noise Density | 1.9nV/sqrt Hz |
| Width | 7.62mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
5962-9313101MPA Overview
Packaged in a Q case, the buffer op amp is ready to use. A OPERATIONAL AMPLIFIER-type buffer amplifier is shown here. In the case of Tube cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. In order to be more specific, this instrumentation amplifier is one of the types of Operational Amplifier devices. 8 pins are included on the operational amplifiers. In terms of the input offset voltage, instrumentation amplifier rates at 500μV. It should not lower than -55°C to operate buffer amplifier. No temperature greater than 125°C should be used. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 1. It is important to keep in mind that the power supply voltage of this electric component is below 18V, which is suitable. It is recommended that you conduct this electronic part using the dual supply voltage of 18V. There is an 16mA quiescent current in linear amplifier.
5962-9313101MPA Features
8 Pins
5962-9313101MPA Applications
There are a lot of Analog Devices Inc. 5962-9313101MPA Instrumentational OP Amps applications.
- High input resistance broadband
- Measurements of Wheatstone bridge
- High speed sample
- Exponential operation circuits
- Medical instruments
- High/low-pass filter circuit
- Commercial audio systems
- Automatic control
- Biopotential
- Strain gauges
