7204L25P
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Through Hole |
| Package / Case | PDIP |
| Number of Pins | 28 |
| Published | 2002 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 28 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Additional Feature | RETRANSMIT |
| HTS Code | 8542.32.00.71 |
| Subcategory | FIFOs |
| Technology | CMOS |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Pin Count | 28 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 120mA |
| Max Supply Current | 120mA |
| Access Time | 25 ns |
| Organization | 4KX9 |
| Density | 36 kb |
| Standby Current-Max | 0.002A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Asynchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| Retransmit Capability | Yes |
| FWFT Support | No |
| Output Enable | NO |
| Cycle Time | 35 ns |
| Height Seated (Max) | 4.699mm |
| Length | 36.6mm |
| Width | 15.24mm |
| Thickness | 3.8mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
7204L25P Overview
PDIP is a package that contains FIFO memory chip.Through Hole is recommended as the mounting method.With a supply voltage of 5V volts, high efficiency is possible.A total of 28 terminations can be found in FIFO means.FIFO design has 28 operation pins.For its operation, 120mA is the maximum current required.When the supply voltage is set to 5V , the FIFO's maximum efficiency is achieved.FIFO operates at a minimum temperature of 0°C degrees Celsius to ensure reliabilFIFOy.By operating at 70°C degrees Celsius, this FIFO products is able to maintain a stable operation.The gadget is self-contained and can be found in FIFOs .A OTHER FIFO memory type IC is used in the part.Typically, FIFO would work at 4.5V volts, but it may also work at higher voltages.FIFO memory is capable of handling a maximum supply voltage of 5.5V volts.Approximately 28 pins are attached to it.Normally, the component owns 5V power supplies.This gadget can also be used to generate RETRANSMIT .
7204L25P Features
FIFOs category
7204L25P Applications
There are a lot of Integrated Device Technology (IDT) 7204L25P FIFOs Memory applications.
- Rate buffers
- Cardiac Monitoring Device
- IP Camera Buffer
- Firmware loaders
- Wireless
- Communications Systems
- Portable Information Devices
- High-speed disk
- Controlled baseline
- Test site
