7206L50J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 32 |
| Published | 2000 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Additional Feature | RETRANSMIT |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 120mA |
| Max Supply Current | 120mA |
| Clock Frequency | 15MHz |
| Access Time | 50 ns |
| Organization | 16KX9 |
| Density | 144 kb |
| Standby Current-Max | 0.008A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Asynchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| Retransmit Capability | Yes |
| FWFT Support | No |
| Output Enable | NO |
| Cycle Time | 65 ns |
| Height Seated (Max) | 3.556mm |
| Length | 13.97mm |
| Width | 11.43mm |
| Thickness | 2.79mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
7206L50J Overview
The PLCC package contains FIFO memory chip.Surface Mount is recommended as the mounting method.An input voltage of 5V results in high efficiency.A total of 32 terminations are contained within FIFO means.There are 32 pins on the operation pins.The maximum current required for its operation is 120mA .For FIFO's maximum efficiency, the supply voltage should be set to 5V .For reliability, FIFO works at a minimum temperature of 0°C degrees Celsius.The memory logic's maximum operating temperature is 70°C °C, which allows for stable operation.A self-contained gadget is contained in FIFOs .A OTHER FIFO memory type IC is used in the part.Typically, FIFO would work at 4.5V volts, but it may also work at higher voltages.A maximum supply voltage of 5.5V V can be handled by this FIFO memory chip.A total of 32 pins are present on the FIFO memory IC.It is normal for a component to be equipped with 5V power supplies.Additionally, this FIFO memory is capable of generating RETRANSMIT as well.FIFO memory ICs run at a frequency of 15MHz .
7206L50J Features
FIFOs category
Clock frequency of 15MHz
7206L50J Applications
There are a lot of Integrated Device Technology (IDT) 7206L50J FIFOs Memory applications.
- Extended product-change notification
- Programmable Logic Controller
- IP Camera Buffer
- Switches
- Event Recorder
- Microprogramming
- Product traceability
- Communications
- Address mapping
- Disk Controllers
