72211L15J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 32 |
| Published | 2005 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Frequency | 66.7MHz |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 35mA |
| Max Supply Current | 35mA |
| Frequency (Max) | 66.7MHz |
| Access Time | 10 ns |
| Organization | 512X9 |
| Density | 4.5 kb |
| Standby Current-Max | 0.08A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 15 ns |
| Height Seated (Max) | 3.556mm |
| Length | 13.97mm |
| Width | 11.43mm |
| Thickness | 2.79mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
72211L15J Overview
You will find FIFO memory chip in the PLCC package.The recommended mounting method for this FIFO products is Surface Mount .If the supply voltage is set to 5V , high efficiency can be achieved.I found that it has 32 terminations in FIFO means.Operation pins are 32 .The maximum current required for its operation is 35mA .In order to maximize efficiency, the supply voltage should be set to 5V .This FIFO products runs at 0°C degrees Celsius at a minimum temperature to ensure reliability.An operating temperature of 70°C °C is necessary for stable operation.It is contained within FIFOs .A OTHER FIFO memory type IC is used in the part.It is possible to operate the FIFO memory chip at very low supply voltages, such as 4.5V volts.The memory logic's maximum supply voltage is 5.5V volts.Currently, it has 32 pins.When the frequency is set to 66.7MHz it can maintain good accuracy.There is 66.7MHz FIFO memory IC's maximum value for regular operation.Components normally possess 5V power supplies.
72211L15J Features
FIFOs category
Frequency at most
72211L15J Applications
There are a lot of Integrated Device Technology (IDT) 72211L15J FIFOs Memory applications.
- Smart Meter
- A/D output buffers
- Tape controllers
- Industrial Systems
- Measurement Equipment
- Wireless
- Data communications
- Laser Receiver System
- Signal processing
- SPD for DDR3 Memory Modules
