72211L25J8
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 32 |
| Published | 2005 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Frequency | 40MHz |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 35mA |
| Max Supply Current | 35mA |
| Frequency (Max) | 40MHz |
| Access Time | 15 ns |
| Organization | 512X9 |
| Density | 4.5 kb |
| Standby Current-Max | 0.08A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 25 ns |
| Height Seated (Max) | 3.556mm |
| Length | 13.97mm |
| Width | 11.43mm |
| Thickness | 2.79mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
72211L25J8 Overview
You can find FIFO memory chip in the PLCC package.Mounting it in the Surface Mount way is recommended.A supply voltage of 5V allows for high efficiency.I found that it has 32 terminations in FIFO means.As far as the operation pins are concerned, they are 32 pins.In order for FIFO design to operate, a maximum current of 35mA is required.A 5V supply voltage will ensure FIFO's maximum efficiency.FIFO operates at a minimum temperature of 0°C degrees Celsius to ensure reliabilFIFOy.By using a memory logic's maximum operating temperature of 70°C degrees Celsius, stable operation can be achieved.It is contained within FIFOs .ICs of type OTHER FIFO are used in the FIFO memory chip.FIFO may operate at a very low supply voltage, such as 4.5V V.The FIFO memory chip is capable of handling maximum supply voltages of 5.5V volts.Approximately 32 pins are attached to it.With a frequency of 40MHz , it exhibits good accuracy.For regular operation, the memory logic's maximum value is 40MHz .Normally, the component owns 5V power supplies.
72211L25J8 Features
FIFOs category
Frequency at most
72211L25J8 Applications
There are a lot of Integrated Device Technology (IDT) 72211L25J8 FIFOs Memory applications.
- TVs
- Disk Controllers
- Signal processing
- Data communications
- Alarm System
- Battery Charger
- Laser Receiver System
- Communications
- Video time base correction
- Switches
