72215LB10J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 68 |
| Published | 2000 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 68 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| HTS Code | 8542.32.00.71 |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Frequency | 100MHz |
| Pin Count | 68 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 60mA |
| Max Supply Current | 60mA |
| Frequency (Max) | 100MHz |
| Access Time | 6.5 ns |
| Organization | 512X18 |
| Density | 9 kb |
| Standby Current-Max | 0.005A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 18b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 10 ns |
| Height Seated (Max) | 4.572mm |
| Length | 24mm |
| Width | 24mm |
| Thickness | 3.63mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
72215LB10J Overview
This package is included in PLCC .A Surface Mount mounting method is recommended.A supply voltage of 5V allows for high efficiency.FIFO means contains 68 terminations.In the case of the operation pins, they are 68 pins.There is a maximum current requirement of 60mA for its operation.A voltage of 5V should be used for FIFO's maximum efficiency.The FIFO products must be run at a minimum temperature of 0°C degrees Celsius to ensure reliability.By operating at a temperature of 70°C °C, the FIFO products is capable of stable operation.It is contained within FIFOs .The IC of the part is OTHER FIFO memory type.FIFO memory chips may be operated at very low supply voltages, such as 4.5V volts.A maximum supply voltage of 5.5V volts can be handled by the FIFO memory chip.It consists of a total of 68 pins.A frequency of 100MHz is capable of maintaining good accuracy.A FIFO memory's maximum value of 100MHz can be used for regular operation.Normally, 5V power supplies are owned by the component.
72215LB10J Features
FIFOs category
Frequency at most
72215LB10J Applications
There are a lot of Integrated Device Technology (IDT) 72215LB10J FIFOs Memory applications.
- Thermal Management for DDR3 Memory Modules
- Disk Controllers
- High-speed graphics pixel buffer
- Game Controller
- Data
- PC peripheral
- IP Camera Buffer
- Test site
- Event Recorder
- Network bridges
