72221L10PF
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | TQFP |
| Number of Pins | 32 |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.8mm |
| Frequency | 100MHz |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 35mA |
| Max Supply Current | 35mA |
| Frequency (Max) | 100MHz |
| Access Time | 6.5 ns |
| Organization | 1KX9 |
| Density | 9 kb |
| Standby Current-Max | 0.005A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 10 ns |
| Height Seated (Max) | 1.6mm |
| Length | 7mm |
| Width | 7mm |
| Thickness | 1.4mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
72221L10PF Overview
You will find FIFO memory chip in the TQFP package.The recommended mounting way is Surface Mount .When the supply voltage is 5V there is the possibility of high efficiency.FIFO means contains 32 terminations.These are the 32 pins for operation.In order to operate FIFO design, a maximum current of 35mA is required.FIFO is recommended that the supply voltage be set to 5V in order to maximize efficiency.For reliability, FIFO works at a minimum temperature of 0°C degrees Celsius.Keeping the operating temperature at 70°C °C allows the FIFO products to operate continuously.It is contained within FIFOs .The IC of the part is of the type OTHER FIFO .Typically, FIFO would work at 4.5V volts, but it may also work at higher voltages.There is a maximum supply voltage of 5.5V volts that FIFO memory can handle.The FIFO memory IC has a total of 32 pins.When the frequency is set to 100MHz , the system can maintain good accuracy.Normally, the FIFO memory's maximum value is 100MHz .Normally, the component owns 5V power supplies.
72221L10PF Features
FIFOs category
Frequency at most
72221L10PF Applications
There are a lot of Integrated Device Technology (IDT) 72221L10PF FIFOs Memory applications.
- Analog-to-digital converters
- Routers
- Disk Controllers
- Emulators
- HDD
- Programmable Logic Controller
- Measurement Equipment
- Consumer Systems
- IP Radio
- Firmware loaders
