72241L25PF8
| Parameters | |
|---|---|
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.8mm |
| Frequency | 40MHz |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 35mA |
| Max Supply Current | 35mA |
| Frequency (Max) | 40MHz |
| Access Time | 15 ns |
| Organization | 4KX9 |
| Density | 36 kb |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 25 ns |
| Height Seated (Max) | 1.6mm |
| Length | 7mm |
| Width | 7mm |
| Thickness | 1.4mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | TQFP |
| Number of Pins | 32 |
| Published | 2008 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 32 |
72241L25PF8 Overview
You can find FIFO memory chip in the TQFP package.Mounting it in Surface Mount is recommended.A supply voltage of 5V allows for high efficiency.32 terminations are contained in FIFO means.FIFO design has 32 operation pins.FIFO design requires a maximum current of 35mA to operate.The supply voltage should be set to 5V in order to achieve FIFO's maximum efficiency.To ensure reliabilFIFOy, FIFO runs at a minimum working temperature of 0°C degrees Celsius.Keeping the operating temperature at 70°C °C allows the FIFO products to operate continuously.The gadget in FIFOs is self-contained.There is a memory type OTHER FIFO in the IC of this part.Typically, FIFO would work at 4.5V volts, but it may also work at higher voltages.A maximum supply voltage of 5.5V volts can be handled by the FIFO memory chip.This FIFO memory IC is equipped with 32 pins in total.With a frequency of 40MHz , it exhibits good accuracy.40MHz is the FIFO memory IC's maximum value for regular operation.Normally, 5V power supplies are owned by the component.
72241L25PF8 Features
FIFOs category
Frequency at most
72241L25PF8 Applications
There are a lot of Integrated Device Technology (IDT) 72241L25PF8 FIFOs Memory applications.
- Network bridges
- Controlled baseline
- Firmware loaders
- Switches
- TVs
- GPS Offender Tracking
- Down-Hole Energy Drilling
- Consumer
- Emulators
- IP Radio
