72251L10PFG
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Package / Case | LQFP |
| Published | 2013 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| HTS Code | 8542.32.00.71 |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.8mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 32 |
| JESD-30 Code | S-PQFP-G32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Max Supply Current | 50mA |
| Frequency (Max) | 100MHz |
| Access Time | 6.5 ns |
| Organization | 8KX9 |
| Memory Width | 9 |
| Standby Current-Max | 0.005A |
| Memory Density | 73728 bit |
| Parallel/Serial | PARALLEL |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 10 ns |
| Height Seated (Max) | 1.6mm |
| Length | 7mm |
| Width | 7mm |
| RoHS Status | RoHS Compliant |
72251L10PFG Overview
The LQFP package contains FIFO memory chip.A Surface Mount mounting method is recommended.With a supply voltage of 5V volts, high efficiency is possible.A total of 32 terminations are contained within FIFO means.The maximum current required for its operation is 50mA .A voltage of 5V should be used for FIFO's maximum efficiency.In order to ensure reliability, FIFO is maintained at 0°C degrees Celsius at all times.By operating at a temperature of 70°C °C, the FIFO products is capable of stable operation.A self-contained gadget is contained within FIFOs .This part is equipped with an IC of type OTHER FIFO memory.Typically, FIFO would work at 4.5V volts, but it may also work at higher voltages.There is a maximum supply voltage of 5.5V volts that FIFO memory can handle.A total of 32 pins are present on the FIFO memory IC.A FIFO memory's maximum value of 100MHz can be used for regular operation.Normally, the component owns 5V power supplies.
72251L10PFG Features
FIFOs category
Frequency at most
72251L10PFG Applications
There are a lot of Integrated Device Technology (IDT) 72251L10PFG FIFOs Memory applications.
- Application that requires re-writable nonvolatile parameter memory
- General Data Collection Applications at Extreme High-Temperatures
- Networking
- Extended product life cycle
- Fabrication Site
- Firmware loaders
- Consumer
- Industrial Systems
- Tape controllers
- Game Consoles
