72251L25J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 32 |
| Published | 2005 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Frequency | 40MHz |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 50mA |
| Max Supply Current | 50mA |
| Frequency (Max) | 40MHz |
| Access Time | 15 ns |
| Organization | 8KX9 |
| Density | 72 kb |
| Standby Current-Max | 0.08A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 25 ns |
| Height Seated (Max) | 3.556mm |
| Length | 13.97mm |
| Width | 11.43mm |
| Thickness | 2.79mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
72251L25J Overview
FIFO memory chip can be found in the PLCC package.The recommended mounting method for this FIFO products is Surface Mount .With a supply voltage of 5V volts, high efficiency is possible.The number of terminations in FIFO means is 32 .Operation pins are 32 .In order for FIFO design to operate, a maximum current of 50mA is required.A voltage of 5V should be used for FIFO's maximum efficiency.FIFO operates at a minimum temperature of 0°C degrees Celsius to ensure reliabilFIFOy.An operating temperature of 70°C °C is necessary for stable operation.It is self-contained in FIFOs .The IC of the part is OTHER FIFO memory type.Low supply voltages, such as 4.5V V, may be required for operation.This FIFO memory chip can handle maximum supply voltages of 5.5V volts.It has a total of 32 pins on it.When the frequency is set to 40MHz it can maintain good accuracy.Normally, the FIFO memory's maximum value is 40MHz .It is normal for a component to be equipped with 5V power supplies.
72251L25J Features
FIFOs category
Frequency at most
72251L25J Applications
There are a lot of Integrated Device Technology (IDT) 72251L25J FIFOs Memory applications.
- Data communications
- MP3 Interface for Automobile
- Extended product life cycle
- A/D output buffers
- SPD for DDR3 Memory Modules
- Computer Systems
- Code converters
- Disk Controllers
- Down-Hole Energy Drilling
- Firmware loaders
