72251L25J8
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Package / Case | PLCC |
| Number of Pins | 32 |
| Published | 2005 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | J BEND |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Frequency | 40MHz |
| Pin Count | 32 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Element Configuration | Dual |
| Nominal Supply Current | 50mA |
| Max Supply Current | 50mA |
| Frequency (Max) | 40MHz |
| Access Time | 15 ns |
| Organization | 8KX9 |
| Density | 72 kb |
| Standby Current-Max | 0.08A |
| Parallel/Serial | PARALLEL |
| Sync/Async | Synchronous |
| Word Size | 9b |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| FWFT Support | No |
| Programmable Flags Support | Yes |
| Output Enable | YES |
| Cycle Time | 25 ns |
| Height Seated (Max) | 3.556mm |
| Length | 13.97mm |
| Width | 11.43mm |
| Thickness | 2.79mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
72251L25J8 Overview
The PLCC package contains FIFO memory chip.Mounting it Surface Mount is recommended.When the supply voltage is 5V there is the possibility of high efficiency.FIFO means contains 32 terminations.There are 32 pins on the operation pins.In order to operate FIFO design, a maximum current of 50mA is required.For FIFO's maximum efficiency, the supply voltage should be set to 5V .This FIFO products runs at 0°C degrees Celsius at a minimum temperature to ensure reliability.An operating temperature of 70°C °C is necessary for stable operation.In FIFOs , this gadget is self-contained.A OTHER FIFO type memory IC is present in the FIFO memory chip.FIFO memory chips may be operated at very low supply voltages, such as 4.5V volts.An input voltage of 5.5V V is the maximum that FIFO memory can handle.As a result, it contains a total of 32 pins.When the frequency is set to 40MHz it can maintain good accuracy.Regular operation has a FIFO memory's maximum value of 40MHz .There are normally 5V power supplies attached to the component.
72251L25J8 Features
FIFOs category
Frequency at most
72251L25J8 Applications
There are a lot of Integrated Device Technology (IDT) 72251L25J8 FIFOs Memory applications.
- A/D output buffers
- Test site
- IP Radio
- Data
- SPI Bus Flash Memory Device
- Measurement Equipment
- Cardiac Monitoring Device
- Multi-stage synchronizer
- Fabrication Site
- Tape controllers
