74ACT273SCX
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 20 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 1998 |
| Series | 74ACT |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 4.5V~5.5V |
| Base Part Number | 74ACT273 |
| Function | Master Reset |
| Output Type | Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Circuits | 8 |
| Output Current | 24mA |
| Clock Frequency | 189MHz |
| Propagation Delay | 8.5 ns |
| Turn On Delay Time | 6.5 ns |
| Logic Function | D-Type, Flip-Flop |
| Current - Quiescent (Iq) | 40μA |
| Current - Output High, Low | 24mA 24mA |
| Max Propagation Delay @ V, Max CL | 8.5ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4.5pF |
| Number of Input Lines | 3 |
| Clock Edge Trigger Type | Positive Edge |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
74ACT273SCX Overview
20-SOIC (0.295, 7.50mm Width)is the packaging method. D flip flop is included in the Tape & Reel (TR)package. It is configured with Non-Invertedas an output. It is configured with the trigger Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. It is at -40°C~85°C TAdegrees Celsius that the system is operating. A flip flop of this type is classified as a D-Type. FPGAs belonging to the 74ACTseries contain this type of chip. Its output frequency should not exceed 189MHz Hz. A total of 1 elements are present. As a result, it consumes 40μA quiescent current. If you search by 74ACT273, you will find similar parts. A 4.5pFfarad input capacitance is provided by this T flip flop. In this case, the electronic component is mounted in the way of Surface Mount. The 20pins are designed into the board. This device's clock edge trigger type is Positive Edge. 8 circuits are used to achieve its superior flexibility. The supply voltage should be maintained at 5V for high efficiency. As a result of its output current of 24mA, it is very flexible in terms of design. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.
74ACT273SCX Features
Tape & Reel (TR) package
74ACT series
20 pins
74ACT273SCX Applications
There are a lot of ON Semiconductor 74ACT273SCX Flip Flops applications.
- High Performance Logic for test systems
- Registers
- Single Up Count-Control Line
- Digital electronics systems
- QML qualified product
- Safety Clamp
- Storage registers
- Individual Asynchronous Resets
- Consumer
- EMI reduction circuitry
