74ACT74SCX
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 14-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 14 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 1998 |
| Series | 74ACT |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 4.5V~5.5V |
| Base Part Number | 74ACT74 |
| Function | Set(Preset) and Reset |
| Output Type | Differential |
| Operating Supply Voltage | 5V |
| Polarity | Non-Inverting |
| Voltage | 5V |
| Number of Circuits | 2 |
| Clock Frequency | 210MHz |
| Propagation Delay | 13 ns |
| Turn On Delay Time | 7.5 ns |
| Logic Function | AND, D-Type, Flip-Flop |
| Current - Quiescent (Iq) | 20μA |
| Current - Output High, Low | 24mA 24mA |
| Number of Bits per Element | 1 |
| Max Propagation Delay @ V, Max CL | 11ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4.5pF |
| Number of Output Lines | 1 |
| Clock Edge Trigger Type | Positive Edge |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
74ACT74SCX Overview
14-SOIC (0.154, 3.90mm Width)is the packaging method. The Tape & Reel (TR)package contains it. T flip flop is configured with an output of Differential. Positive Edgeis the trigger it is configured with. Surface Mountis in the way of this electric part. A voltage of 4.5V~5.5Vis used as the supply voltage. Currently, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. JK flip flop is a part of the 74ACTseries of FPGAs. This D flip flop should not have a frequency greater than 210MHz. There is 20μA quiescent consumption. If you search by 74ACT74, you will find similar parts. The input capacitance of this JK flip flopis 4.5pF farads. There is an electronic component mounted in the way of Surface Mount. This board has 14 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. Using 2 circuits, it is highly flexible. For high efficiency, the supply voltage should be kept at 5V. The JK flip flop is with 1 output lines to operate.
74ACT74SCX Features
Tape & Reel (TR) package
74ACT series
14 pins
74ACT74SCX Applications
There are a lot of ON Semiconductor 74ACT74SCX Flip Flops applications.
- Storage registers
- Single Up Count-Control Line
- Shift registers
- ESD protection
- Frequency Dividers
- Memory
- Storage Registers
- Matched Rise and Fall
- Buffered Clock
- Cold spare funcion
