74AHCT273D-Q100J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 20 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2013 |
| Series | 74AHCT |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 20 |
| Type | D-Type |
| Technology | CMOS |
| Voltage - Supply | 4.5V~5.5V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Supply Voltage | 5V |
| Base Part Number | 74AHCT273 |
| Function | Master Reset |
| Output Type | Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Clock Frequency | 75MHz |
| Propagation Delay | 14 ns |
| Quiescent Current | 4μA |
| Family | AHCT/VHCT/VT |
| Current - Output High, Low | 8mA 8mA |
| Number of Bits per Element | 8 |
| Max Propagation Delay @ V, Max CL | 9.2ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 3pF |
| fmax-Min | 65 MHz |
| Clock Edge Trigger Type | Positive Edge |
| Height Seated (Max) | 2.65mm |
| Width | 7.5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
74AHCT273D-Q100J Overview
As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). The Tape & Reel (TR)package contains it. T flip flop uses Non-Invertedas its output configuration. This trigger is configured to use Positive Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. -40°C~125°C TAis the operating temperature. It belongs to the type D-Typeof flip flops. FPGAs belonging to the 74AHCTseries contain this type of chip. It should not exceed 75MHzin terms of its output frequency. In total, it contains 1 elements. A total of 20 terminations have been made. The 74AHCT273 family contains it. An input voltage of 5Vpowers the D latch. This T flip flop has a capacitance of 3pF farads at the input. It is a member of the AHCT/VHCT/VTfamily of D flip flop. The electronic part is mounted in the way of Surface Mount. 20pins are included in its design. The clock edge trigger type for this device is Positive Edge. The supply voltage should be maintained at 5V for high efficiency. 4μAquiescent current consumed.
74AHCT273D-Q100J Features
Tape & Reel (TR) package
74AHCT series
20 pins
74AHCT273D-Q100J Applications
There are a lot of Nexperia USA Inc. 74AHCT273D-Q100J Flip Flops applications.
- Buffered Clock
- Modulo – n – counter
- Event Detectors
- Load Control
- Control circuits
- Functionally equivalent to the MC10/100EL29
- Circuit Design
- Storage registers
- Shift registers
- Registers
