74FCT162373ATPAG
| Parameters | |
|---|---|
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 48 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | FF/Latches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 48 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Load Capacitance | 50pF |
| Number of Ports | 2 |
| Number of Bits | 16 |
| Propagation Delay | 8.5 ns |
| Turn On Delay Time | 1.5 ns |
| Family | FCT |
| Logic Function | D-Type, Latch |
| Output Characteristics | 3-STATE |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | 24mA |
| Low Level Output Current | 24mA |
| Independent Circuits | 2 |
| Length | 12.5mm |
| Width | 6.1mm |
| Thickness | 1mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 48 |
| Published | 2007 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
74FCT162373ATPAG Overview
The package in which it is embedded is named TSSOP. 16 Bits are used in the design of this electronic part. There are 48 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The device is operated when the supply voltage is set to 5V. There are 48 pins on it. FCT is the family name of this electronic device. There are 48 pins on it. The electronic part is mounted using the Surface Mount method. This device is equipped with 2 ports. There is a subcategory of FF/Latches for this part. A total of 5V power supplies are needed to run it. For maximum efficiency, the supply voltage should be set to 5V. 24mA is the low level output current. 24mA is set as the high level output current. A temperature below 85°C should be used for operation. It is recommended that the operating temperature be higher than -40°C. There is a maximum voltage of 5.5V supported. With a minimum supply voltage of 4.5V, it operates. BUS DRIVER is the logic IC it uses.
74FCT162373ATPAG Features
TSSOP package
16 Bits
48 pin count
48 pins
5V power supplies
74FCT162373ATPAG Applications
There are a lot of Integrated Device Technology (IDT) 74FCT162373ATPAG Latches applications.
- Sample and hold register
- OC-48 communication systems
- Hammer
- General-Purpose Register
- A/D converters
- Frequency dividing
- Automatic test equipment
- A/D and D/A conversion
- Timers
- Communication systems
