74HC175D-Q100J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2014 |
| Series | 74HC |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Type | D-Type |
| Technology | CMOS |
| Voltage - Supply | 2V~6V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Supply Voltage | 5V |
| Base Part Number | 74HC175 |
| Function | Master Reset |
| Output Type | Differential |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2V |
| Clock Frequency | 89MHz |
| Family | HC/UH |
| Current - Quiescent (Iq) | 8μA |
| Current - Output High, Low | 5.2mA 5.2mA |
| Number of Bits per Element | 4 |
| Max Propagation Delay @ V, Max CL | 30ns @ 6V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 3.5pF |
| Propagation Delay (tpd) | 265 ns |
| Length | 9.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
74HC175D-Q100J Overview
As a result, it is packaged as 16-SOIC (0.154, 3.90mm Width). It is contained within the Tape & Reel (TR)package. As configured, the output uses Differential. This trigger is configured to use Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 2V~6Vis required for its operation. -40°C~125°C TAis the operating temperature. The type of this D latch is D-Type. In this case, it is a type of FPGA belonging to the 74HC series. It should not exceed 89MHzin its output frequency. D latch consists of 1 elements. There is 8μA quiescent consumption. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. JK flip flop belongs to 74HC175 family. Power is supplied from a voltage of 5V volts. This T flip flop has a capacitance of 3.5pF farads at the input. HC/UHis the family of this D flip flop. Surface Mount mounts this electronic component. It reaches 6Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be kept above 2V. If high efficiency is to be achieved, the supply voltage should be maintained at 5V.
74HC175D-Q100J Features
Tape & Reel (TR) package
74HC series
74HC175D-Q100J Applications
There are a lot of Nexperia USA Inc. 74HC175D-Q100J Flip Flops applications.
- 2 – Bit synchronous counter
- Supports Live Insertion
- Storage Registers
- Single Down Count-Control Line
- Dynamic threshold performance
- Memory
- Individual Asynchronous Resets
- High Performance Logic for test systems
- Communications
- Bounce elimination switch
