74HCT174D-Q100J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2013 |
| Series | 74HCT |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Type | D-Type |
| Technology | CMOS |
| Voltage - Supply | 4.5V~5.5V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Supply Voltage | 5V |
| Base Part Number | 74HCT174 |
| Function | Master Reset |
| Output Type | Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Clock Frequency | 69MHz |
| Propagation Delay | 53 ns |
| Family | HCT |
| Current - Quiescent (Iq) | 8μA |
| Current - Output High, Low | 4mA 5.2mA |
| Number of Bits per Element | 6 |
| Max Propagation Delay @ V, Max CL | 35ns @ 4.5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 3.5pF |
| fmax-Min | 20 MHz |
| Clock Edge Trigger Type | Positive Edge |
| Length | 9.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
74HCT174D-Q100J Overview
16-SOIC (0.154, 3.90mm Width)is the packaging method. Package Tape & Reel (TR)embeds it. T flip flop uses Non-Invertedas the output. There is a trigger configured with Positive Edge. Surface Mountis positioned in the way of this electronic part. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at -40°C~125°C TA. This logic flip flop is classified as type D-Type. In terms of FPGAs, it belongs to the 74HCT series. You should not exceed 69MHzin the output frequency of the device. The element count is 1 . During its operation, it consumes 8μA quiescent energy. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. You can search similar parts based on 74HCT174. It is powered from a supply voltage of 5V. This T flip flop has a capacitance of 3.5pF farads at the input. In this case, the D flip flop belongs to the HCTfamily. A part of the electronic system is mounted in the way of Surface Mount. There are 16pins on it. The clock edge trigger type for this device is Positive Edge. If high efficiency is to be achieved, the supply voltage should be maintained at 5V.
74HCT174D-Q100J Features
Tape & Reel (TR) package
74HCT series
16 pins
74HCT174D-Q100J Applications
There are a lot of Nexperia USA Inc. 74HCT174D-Q100J Flip Flops applications.
- Latch
- CMOS Process
- Frequency Divider circuits
- Common Clocks
- Counters
- Load Control
- Memory
- Shift Registers
- Modulo – n – counter
- Pattern generators
