74LCX821MTCX
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 19 hours ago) |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 24-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 24 |
| Weight | 212mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2001 |
| Series | 74LCX |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 2V~3.6V |
| Base Part Number | 74LCX821 |
| Function | Standard |
| Output Type | Tri-State, Non-Inverted |
| Polarity | Non-Inverting |
| Clock Frequency | 150MHz |
| Propagation Delay | 9.8 ns |
| Quiescent Current | 10μA |
| Turn On Delay Time | 7 ns |
| Logic Function | D-Type, Flip-Flop |
| Current - Output High, Low | 24mA 24mA |
| Number of Bits per Element | 10 |
| Max Propagation Delay @ V, Max CL | 7ns @ 3.3V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 7pF |
| Number of Input Lines | 1 |
| Number of Output Lines | 3 |
| Clock Edge Trigger Type | Positive Edge |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
74LCX821MTCX Overview
The package is in the form of 24-TSSOP (0.173, 4.40mm Width). The Tape & Reel (TR)package contains it. As configured, the output uses Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at 2V~3.6Vvolts. A temperature of -40°C~85°C TAis used in the operation. A flip flop of this type is classified as a D-Type. It belongs to the 74LCXseries of FPGAs. You should not exceed 150MHzin its output frequency. The 74LCX821 family contains this object. The input capacitance of this T flip flop is 7pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. It is mounted by the way of Surface Mount. Basically, it is designed with a set of 24 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The JK flip flop is with 3 output lines to operate. 1input lines are available for you to choose from. Despite external influences, it consumes 10μAof quiescent current.
74LCX821MTCX Features
Tape & Reel (TR) package
74LCX series
24 pins
74LCX821MTCX Applications
There are a lot of ON Semiconductor 74LCX821MTCX Flip Flops applications.
- Convert a momentary switch to a toggle switch
- EMI reduction circuitry
- Storage Registers
- Functionally equivalent to the MC10/100EL29
- Circuit Design
- Matched Rise and Fall
- Balanced Propagation Delays
- Buffer registers
- ATE
- Storage registers
