74LVC1G66GF,132
| Parameters | |
|---|---|
| Terminal Finish | Tin (Sn) |
| Max Power Dissipation | 250mW |
| Technology | CMOS |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 2.7V |
| Terminal Pitch | 0.35mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | 74LVC1G66 |
| Pin Count | 6 |
| Operating Supply Voltage | 5V |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 1nA |
| Number of Ports | 2 |
| Nominal Supply Current | 100mA |
| Max Supply Current | 200μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 5.3 ns |
| Family | LVC/LCX/Z |
| Output Characteristics | 3-STATE |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 4.2 ns |
| Output Polarity | TRUE |
| Logic IC Type | BUS DRIVER |
| -3db Bandwidth | 500MHz |
| On-State Resistance (Max) | 10Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 5μA |
| Channel Capacitance (CS(off), CD(off)) | 6.5pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 4.2ns, 5ns |
| Charge Injection | 7.5pC |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Height Seated (Max) | 0.5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount, Through Hole |
| Mounting Type | Surface Mount |
| Package / Case | 6-XFDFN |
| Number of Pins | 6 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2008 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Resistance | 240Ohm |
74LVC1G66GF,132 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 6-XFDFN. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a number of circuits 1:1. The operating temperature is extended to around -40°C~125°C TA. In total, there have been 6 terminations. An 2.7V voltage supply should allow the electrical part to be turned on and run. Into the electrical component body are injected 6 pins. A SPST - NO switching circuit is used for these analog switches. There are 1 circuits in this switch device. If you are looking for variants of the digital switch, trying search with 74LVC1G66. This digital multiplexer has 240Ohm internal resistance. The functions of 6 pins can be found in the datasheets. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. Dual, Single supply type digital switch with a low cost. It is recommended to use 1.65V as the lowest voltage for the electrical part. This digital switch can be operated with a current of 1nA. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 200μA on the multiplexer may cause damage. Operating voltages of 5V are compatible with the electrical part. 1-bit conductivity is possible.
74LVC1G66GF,132 Features
Switch Circuit: SPST - NO
1nA Supply Current
-3db Bandwidth: 500MHz
1-Bit
74LVC1G66GF,132 Applications
There are a lot of Nexperia USA Inc. 74LVC1G66GF,132 Analog Switches & Multiplexers ICs applications.
- Avionics
- Cell phones
- Power routing
- Relay replacements
- Video switching
- Communications systems
- Audio signal routing
- Precision data acquisition
- DSLAMs
- E1 Network Equipment
