Parameters |
Factory Lead Time |
1 Week |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
6-XFDFN |
Number of Pins |
6 |
Operating Temperature |
-40°C~125°C TA |
Packaging |
Tape & Reel (TR) |
Published |
2001 |
JESD-609 Code |
e3 |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
6 |
Resistance |
15Ohm |
Max Power Dissipation |
250mW |
Technology |
CMOS |
Terminal Position |
DUAL |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
1 |
Supply Voltage |
2.7V |
Terminal Pitch |
0.5mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
74LVC1G66 |
Pin Count |
6 |
Operating Supply Voltage |
5V |
Polarity |
Non-Inverting |
Number of Circuits |
1 |
Max Supply Voltage |
5.5V |
Min Supply Voltage |
1.65V |
Operating Supply Current |
200μA |
Number of Ports |
2 |
Nominal Supply Current |
100nA |
Max Supply Current |
200μA |
Number of Bits |
1 |
Throw Configuration |
SPST |
Turn On Delay Time |
5.3 ns |
Family |
LVC/LCX/Z |
Output Characteristics |
3-STATE |
Supply Type |
Single |
Turn-Off Delay Time |
4.2 ns |
Logic IC Type |
BUS DRIVER |
-3db Bandwidth |
500MHz |
On-State Resistance (Max) |
10Ohm |
High Level Output Current |
50mA |
Low Level Output Current |
50mA |
Multiplexer/Demultiplexer Circuit |
1:1 |
Current - Leakage (IS(off)) (Max) |
5μA |
Channel Capacitance (CS(off), CD(off)) |
6.5pF |
Switch Circuit |
SPST - NO |
Switch Time (Ton, Toff) (Max) |
4.2ns, 5ns |
Charge Injection |
7.5pC |
Voltage - Supply, Single (V+) |
1.65V~5.5V |
Height Seated (Max) |
0.5mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
74LVC1G66GM,132 Overview
The electrical component comes in 6-XFDFN packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. 1:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -40°C~125°C TA. Totally, there are 6 terminations. When the electronic component is given a voltage of 2.7V, it should be turned on and run. An electrical component like this is included in the 6 series. Multiplexers built on a SPST - NO switching circuit are built. Circuits number 1 make up this analogue multiplexer. Try searching for the analog switch ic with 74LVC1G66 if you are looking for variants. An switch multiplexer with 15Ohm internal resistance has a value of 15Ohm. The datasheets for the 6 pins explain the functions. Multiplexers should not be powered above 5.5V in normal situations. Digital switch that provides Single power at a cost-effective price. The lowest voltage the electronic part should receive is 1.65V. For this multiplexer to operate, 200μA current would be sufficient. This analog switch requires a voltage of 1.65V~5.5V to drain from a single voltage supply. A voltage higher than 200μA may cause damage to the switch multiplexer. The electrical part can be operated at 5V voltage levels. It conducts in a 1-bit manner.
74LVC1G66GM,132 Features
Switch Circuit: SPST - NO
200μA Supply Current
-3db Bandwidth: 500MHz
1-Bit
74LVC1G66GM,132 Applications
There are a lot of Nexperia USA Inc. 74LVC1G66GM,132 Analog Switches & Multiplexers ICs applications.
- Avionics and Military Systems
- High-Voltage
- Fiber to the Home
- Relay Replacement
- Precision data acquisition
- Sample hold systems
- Industrial control systems
- MP3 players
- Remote wireless modules
- Data switching