74LVC2G53DC,125

3.8ns, 3.8ns SPDT 10Ohm DUAL Analog Switches 74LVC2G53 8 Pins 5μA 2.7V 8-VFSOP (0.091, 2.30mm Width)

Manufacturer: Nexperia USA Inc.
Nocochips NO: 554-74LVC2G53DC,125
Package: 8-VFSOP (0.091, 2.30mm Width)
Datasheet: PDF
Stock: 730
Description: 3.8ns, 3.8ns SPDT 10Ohm DUAL Analog Switches 74LVC2G53 8 Pins 5μA 2.7V 8-VFSOP (0.091, 2.30mm Width)(Kg)

Details

Tags

Parameters
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	2.7V
Terminal Pitch	0.5mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	74LVC2G53
Pin Count	8
Polarity	Non-Inverting
Number of Channels	2
Number of Circuits	1
Max Supply Voltage	5.5V
Min Supply Voltage	1.65V
Operating Supply Current	40μA
Power Dissipation	250mW
Propagation Delay	800 ps
Turn On Delay Time	6.7 ns
Logic Function	Demultiplexer, Multiplexer
Supply Type	Single
Bandwidth	300MHz
Turn-Off Delay Time	6.8 ns
On-State Resistance (Max)	10Ohm
High Level Output Current	50mA
Low Level Output Current	50mA
Multiplexer/Demultiplexer Circuit	2:1
Off-state Isolation-Nom	40 dB
Current - Leakage (IS(off)) (Max)	5μA
Channel Capacitance (CS(off), CD(off))	6pF
Switch Circuit	SPDT
Switch Time (Ton, Toff) (Max)	3.8ns, 3.8ns
Charge Injection	7.5pC
Voltage - Supply, Single (V+)	1.65V~5.5V
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Factory Lead Time	1 Week
Contact Plating	Gold
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-VFSOP (0.091, 2.30mm Width)
Number of Pins	8
Operating Temperature	-40°C~125°C TA
Packaging	Tape & Reel (TR)
JESD-609 Code	e4
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
Resistance	15Ohm
Max Power Dissipation	250mW

74LVC2G53DC,125 Overview

As the electronic part is packed in 8-VFSOP (0.091, 2.30mm Width), international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. 2:1 is the ratio between multiplexers and demultiplexers. An extended operating temperature of -40°C~125°C TA degrees Celsius. Total terminations are 8. This electronic part offers high-quality output due to its 2 channels. When a voltage supply of 2.7V is used, the electronic component should be turned on and run. A total of 8 pins are injected into the body of the electronic part. Circuits based on SPDT switching are used to construct these analog switch ics. A total of 1 circuits make up this switch device. 74LVC2G53 can be used to search for analog multiplexer variants. A 15Ohm internal resistance characterizes this multiplexer. For details about the functions of 8 pins, please refer to the datasheets. Multiplexers should not be powered above 5.5V in normal situations. Single supply type digital switch with a low cost. There should be 1.65V voltage fed to the electrical part below 1.65V. It would be sufficient to run this analogue multiplexer with 40μA current. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. The transfer of data can be performed over 300MHz bandwidths.