74VHCT374AM
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 20 |
| Weight | 801mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | 74VHCT |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 4.5V~5.5V |
| Base Part Number | 74VHCT374 |
| Function | Standard |
| Output Type | Tri-State, Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Circuits | 8 |
| Clock Frequency | 130MHz |
| Propagation Delay | 12.5 ns |
| Turn On Delay Time | 5.6 ns |
| Logic Function | D-Type, Flip-Flop |
| Current - Quiescent (Iq) | 4μA |
| Current - Output High, Low | 8mA 8mA |
| Max Propagation Delay @ V, Max CL | 10.4ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4pF |
| Clock Edge Trigger Type | Positive Edge |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
74VHCT374AM Overview
20-SOIC (0.295, 7.50mm Width)is the way it is packaged. A package named Tubeincludes it. There is a Tri-State, Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at a temperature of -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74VHCTseries FPGA. You should not exceed 130MHzin its output frequency. A total of 1 elements are present. Despite external influences, it consumes 4μAof quiescent current. This D latch belongs to the family of 74VHCT374. A JK flip flop with a 4pFfarad input capacitance is used here. This electronic part is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. A Positive Edgeclock edge trigger is used in this device. Due to its superior flexibility, it uses 8 circuits. In order to ensure high efficiency, the supply voltage should remain at 5V.
74VHCT374AM Features
Tube package
74VHCT series
20 pins
74VHCT374AM Applications
There are a lot of ON Semiconductor 74VHCT374AM Flip Flops applications.
- Guaranteed simultaneous switching noise level
- Registers
- Storage registers
- Latch-up performance
- Data transfer
- Circuit Design
- Bus hold
- Modulo – n – counter
- Functionally equivalent to the MC10/100EL29
- Divide a clock signal by 2 or 4
