A4952ELYTR-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) Exposed Pad |
| Number of Pins | 10 |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 (1 Year) |
| Number of Terminations | 10 |
| Terminal Finish | Matte Tin (Sn) |
| Applications | General Purpose |
| Subcategory | Motion Control Electronics |
| Technology | DMOS |
| Voltage - Supply | 8V~40V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | A4952 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Voltage | 40V |
| Supply Voltage-Min (Vsup) | 8V |
| Interface | Parallel |
| Analog IC - Other Type | BRUSH DC MOTOR CONTROLLER |
| Output Configuration | Half Bridge (2) |
| Output Current-Max | 2A |
| Max Collector Current | 2A |
| Voltage - Load | 8V~40V |
| Motor Type - AC, DC | Brushed DC |
| Height | 860μm |
| Length | 3mm |
| Width | 3mm |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
A4952ELYTR-T Overview
This package was designed with Tape & Reel (TR)in mind.This part is packaged with a case of [0].In most cases, it is recommended to mount the part at Surface Mount.Fits the component connected to General Purpose.The device can supply 8V~40V volts.A range of -40°C~150°C TJis available for operating temperature.A motor of this type can be categorized as Brushed DC.This part provides 10terminations.If the voltage is applied to the load at the rate of [0], the load will be affected.Ideally, it should be mounted in the Surface Mountposition.The device employs the BRUSH DC MOTOR CONTROLLER analog IC.This can be determined by looking at the A4952 part number.The device has 10 pins.Drivers controllers is a part of the Motion Control Electronics series.There are a total of 1outputs available.The output voltage is maintained at 40V.
A4952ELYTR-T Features
Applications : General Purpose
Load voltage across the chip 8V~40V
base on A4952 number
designed with 1 outputs
A4952ELYTR-T Applications
There are a lot of Allegro MicroSystems A4952ELYTR-T motor drivers applications.
- Dash
- Automotive instrumentation
- Hazardous application
- LED ballasts
- Handheld devices
- Commercial office
- Daytime running lights (DRLs)
- Tunnel lights
- Landscape lighting
- RGB and monochromatic LED drivers for signage and traffic signals
