A4986SESTR-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 24-WFQFN Exposed Pad |
| Operating Temperature | -20°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Applications | General Purpose |
| Subcategory | Motion Control Electronics |
| Technology | DMOS |
| Voltage - Supply | 3V~5.5V |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | A4986 |
| JESD-30 Code | S-PQCC-N24 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 3.3/535V |
| Supply Voltage-Min (Vsup) | 3V |
| Interface | Parallel |
| Analog IC - Other Type | STEPPER MOTOR CONTROLLER |
| Output Configuration | Half Bridge (4) |
| Current - Output | 2A |
| Supply Current-Max (Isup) | 8mA |
| Voltage - Load | 8V~35V |
| Motor Type - Stepper | Bipolar |
| Step Resolution | 1, 1/2, 1/4 |
| Height Seated (Max) | 0.8mm |
| Length | 4mm |
| Width | 4mm |
| RoHS Status | ROHS3 Compliant |
A4986SESTR-T Overview
Drivers controllers is designed wDrivers controllersh a package of [0].Parts are packaged in 24-WFQFN Exposed Padcases.To mount the part by [0], it is recommended that you do so.I believe it is suitable for the component connected to General Purpose.In this case, the device can supply 3V~5.5V volts.A range of -20°C~150°C TJis available for operating temperature.There are 24 terminations available on this part.At a rate of [0], voltage can be applied to the load.I would like to remind you that this amplifier should be operated at 3.3V.Its recommended mounting way is Surface Mount.Set the part's output current to 2A.A STEPPER MOTOR CONTROLLERanalog IC is employed in this device.Using the A4986part number, it is located.This is part of the Motion Control Electronics series.There are a total of 1outputs available.
A4986SESTR-T Features
Applications : General Purpose
Load voltage across the chip 8V~35V
base on A4986 number
designed with 1 outputs
A4986SESTR-T Applications
There are a lot of Allegro MicroSystems A4986SESTR-T motor drivers applications.
- Mobile phone display backlight and key light driving
- Architectural lighting
- LED bias
- Horticultural lighting
- Step-up or step-down driver topologies
- General lighting
- CHMSL (center high-mount stop lamps)
- Scanning equipment
- Camcorders
- Footwell lighting
