AD5751BCPZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | PRODUCTION (Last Updated: 2 weeks ago) |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 32-VFQFN Exposed Pad, CSP |
| Number of Pins | 32 |
| Operating Temperature | -40°C~105°C |
| Packaging | Tray |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 32 |
| ECCN Code | EAR99 |
| Subcategory | Peripheral Drivers |
| Max Power Dissipation | 108mW |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Base Part Number | AD5751 |
| Pin Count | 32 |
| Operating Supply Voltage | 55V |
| Supply Voltage-Max (Vsup) | 5.5V |
| Number of Channels | 1 |
| Operating Supply Current | 5.2mA |
| Nominal Supply Current | 5.2mA |
| Slew Rate | 2V/μs |
| Amplifier Type | Instrumentation |
| Voltage - Supply, Single/Dual (±) | 10.8V~55V |
| Output Current per Channel | 24mA |
| Input Offset Voltage (Vos) | 17mV |
| Power Supply Rejection Ratio (PSRR) | 65dB |
| Settling Time | 7 μs |
| Interface IC Type | BUFFER OR INVERTER BASED PERIPHERAL DRIVER |
| Output Peak Current Limit-Nom | 0.015A |
| Built-in Protections | OVER CURRENT |
| Output Current Flow Direction | SINK |
| Height | 950μm |
| Length | 5mm |
| Width | 5mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
AD5751BCPZ Overview
Op amp is packaged in 32-VFQFN Exposed Pad, CSP case. There are two types of operational amplifiers in this circuit. In the case of Tray cases, linear amplifier will be delivered. It is estimated that there will be 32 terminations in the next few months. There are a total of 32 pins on this op amp. This linear amplifier should be powered by an 3V battery. In order to be more specific, this instrumentation amplifier is one of the types of Peripheral Drivers devices. 32 pins are included on the operational amplifiers. Op amp rates 17mV as input offset voltage. The mounting type that is recommended for this electrical part is Surface Mount. According to the manufacturer, this buffer op amp works well at -40°C~105°C , which is a good operating temperature. An 5.2mA volt supply current is needed for this linear amplifier to operate. 1 channels are available on the instrumentation amplifier. The operating supply voltage of instrumentation amplifier is rated 55V voltage. This electrical part has a BUFFER OR INVERTER BASED PERIPHERAL DRIVER interface IC type.
AD5751BCPZ Features
32 Pins
supply voltage of 3V
AD5751BCPZ Applications
There are a lot of Analog Devices Inc. AD5751BCPZ Instrumentational OP Amps applications.
- Automotive sensors
- Large motor controllers
- single/dual op amp sum and difference circuits
- earphone
- Proportional counter tubes
- Micro signal measurement
- Proportional operation circuits
- Medical imaging
- Vehicle electronics
- Video data acquisition
