AD8532AR-REEL7
| Parameters | |
|---|---|
| Package / Case | R |
| Surface Mount | YES |
| Number of Pins | 8 |
| Packaging | Tape and Reel |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 8 |
| Power Supplies | 3/5V |
| Number of Circuits | 2 |
| Max Supply Voltage | 6V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 750μA |
| Quiescent Current | 1.25mA |
| Supply Current-Max | 3.5mA |
| Slew Rate | 5 V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Common Mode Rejection Ratio | 47 dB |
| Current - Input Bias | 5pA |
| Output Current per Channel | 250mA |
| Input Offset Voltage (Vos) | 25mV |
| Gain Bandwidth Product | 3MHz |
| Unity Gain BW-Nom | 2200 kHz |
| Voltage Gain | 98.06dB |
| Average Bias Current-Max (IIB) | 0.00006μA |
| Power Supply Rejection Ratio (PSRR) | 55dB |
| Low-Offset | NO |
| Frequency Compensation | YES |
| Low-Bias | YES |
| Micropower | NO |
| Bias Current-Max (IIB) @25C | 0.00005μA |
| Programmable Power | NO |
| Wideband | NO |
| Input Voltage Noise Density | 45nV/sqrt Hz |
| Height Seated (Max) | 1.75mm |
| Length | 4.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
AD8532AR-REEL7 Overview
It is packaged in an R-case that protects the operational amplifiers from damage. As far as the packaging is concerned, buffer op amp is delivered in a Tape and Reel case. It is estimated that there will be 8 terminations in the next few months. In total, there are 8 pins on this op amp ic. It would be helpful if you could remember that this op amp ic should be powered by an 3V battery. It has 8 pins that make up the linear amplifier. As far as the input offset voltage is concerned, linear amplifier rates at 25mV. Operational amplifier can operate supply current at 750μA. Maintain 98.06dB as the voltage gain. On this buffer amplifier, there are 2 circuits. It should not lower than -40°C to operate buffer amplifier. Use op amps only at temperatures no higher than 85°C. I would like to point out that this electrical component is capable of working from a voltage below 6V as far as the power supply is concerned. It is advised to keep the op amp's supply voltage higher than 2.7V. As a result, linear amplifier's quiescent current is 1.25mA.
AD8532AR-REEL7 Features
8 Pins
supply voltage of 3V
98.06dB voltage gain
AD8532AR-REEL7 Applications
There are a lot of Analog Devices, Inc. AD8532AR-REEL7 Instrumentational OP Amps applications.
- Gaming industry
- Large motor controllers
- Broadcasting
- Tablets
- Automation control systems
- Power generator
- Test and measurement instruments
- Inverse/same-phase proportional circuit
- Industrial applications including automation
- Signal transformation
