AD8566ARM-REEL

600nA 54 dB Instrumentational OP Amps 8 Pins MSOP

Manufacturer: Analog Devices, Inc.
Nocochips NO: 84-AD8566ARM-REEL
Package: MSOP
Datasheet: PDF
Stock: 902
Description: 600nA 54 dB Instrumentational OP Amps 8 Pins MSOP(Kg)

Details

Tags

Parameters
Contact Plating	Lead, Tin
Mount	Surface Mount
Package / Case	MSOP
Number of Pins	8
Packaging	Tape and Reel
JESD-609 Code	e0
Moisture Sensitivity Level (MSL)	1
Number of Terminations	8
ECCN Code	EAR99
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Operational Amplifiers
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	240
Number of Functions	2
Supply Voltage	4.5V
Terminal Pitch	0.65mm
Reach Compliance Code	not_compliant
Time@Peak Reflow Temperature-Max (s)	30
Pin Count	8
Qualification Status	Not Qualified
Number of Elements	2
Temperature Grade	INDUSTRIAL
Max Supply Voltage	16V
Min Supply Voltage	4.5V
Slew Rate	6 V/μs
Architecture	VOLTAGE-FEEDBACK
Amplifier Type	OPERATIONAL AMPLIFIER
Common Mode Rejection Ratio	54 dB
Current - Input Bias	600nA
Input Offset Voltage (Vos)	10mV
Gain Bandwidth Product	5MHz
Unity Gain BW-Nom	5000 kHz
Voltage Gain	80dB
Power Supply Rejection Ratio (PSRR)	70dB
Low-Offset	NO
Frequency Compensation	YES
Low-Bias	NO
Micropower	NO
Bias Current-Max (IIB) @25C	0.6μA
Programmable Power	NO
Wideband	NO
Height Seated (Max)	1.1mm
Length	3mm
RoHS Status	Non-RoHS Compliant

AD8566ARM-REEL Overview

There is a MSOP case package that contains the instrumentation amplifiers. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a Tape and Reel case that is delivered with the instrumentation amplifiers. It is estimated that there will be 8 terminations in the next few months. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 4.5V battery. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifiers device. 8 pins are located on the operational amplifiers. Op amp rates 10mV as input offset voltage. There should be no change in the voltage gain at 80dB. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. In order to avoid damage to the product, operational amplifiers should only be used at temperatures below 85°C. As a whole, there are 2 elements that make up this buffer amplifier. I would like to point out that this electrical component is capable of working from a voltage below 16V as far as the power supply is concerned. To keep the buffer amps' supply voltage higher than 4.5V.